SYS-CP842-1.1E.pdf - 第224页
SYS-CP842-1.1E 6.System Installation and Upgrade CP-842E / CP-842ME System Reference 215 6.1.3 Installing the Machine Control Software 1. With th e reboot dialog box displayed (f rom the previous section) , replace the S…
6.System Installation
and Upgrade SYS-CP842-1.1E
214 CP-842E / CP-842ME System Reference
6.1.2 Installing the Operating System
The System Software Recovery Media CD-ROM is used to install the system software.
1. At the exit dialog box for the BIOS settings, insert the System Software Recovery Media
CD-ROM into the CD drive, then select [Yes] at the dialog box. When the BIOS setting
operation is ended in this manner (with CD-ROM inserted), the system software installer
is automatically started, and installation begins.
2. When the installer begins, the license information of the Easy-Restore used for the
system recovery displays together with the message, Strike a key when ready at the
bottom of the screen. Press the SPACE key to proceed. Press the SPACE key three
times to reach the end of the license information and the installer.
When the operating system installation is complete, a dialog box displays asking you to
reboot ([Reboot] button displays).
3. Do not select reboot yet because you must replace the System Software Recovery
Media with the machine control software CD-ROM first. (Proceed to next section
Installing the Machine Control Software.)
Note: Do not restart with the System Software Recovery Media CD-ROM inserted, as this will reinstall
Windows NT.
SYS-CP842-1.1E 6.System Installation
and Upgrade
CP-842E / CP-842ME System Reference 215
6.1.3 Installing the Machine Control Software
1. With the reboot dialog box displayed (from the previous section), replace the System
Software Recovery Media CD-ROM with the machine control software CD-ROM. Now
you can reboot the system (press [ENTER] on the keyboard). After rebooting, Windows
NT is started, and the system installation starts automatically.
Note: If rebooting occurs without the CD-ROM inserted, Windows NT starts, and the following message
displays: Cant find shortcut link which starts Setup.EXE. If this occurs, click [OK] and insert the
application CD-ROM. The installation starts automatically.
2. When installation starts, the [Setup] screen displays together with a Yes/No confirmation
message asking whether to proceed with the installation. Select [Yes] to proceed to the
product ID input screen.
3. Enter the product ID and click [Next].
At the confirmation dialog box which then displays, verify that the ID is correct. If the ID
is incorrect, click [No] to return to the product ID input screen. If the ID is correct, click
[Yes] to continue with the installation. The remainder of the application installation is
performed automatically.
4. A message displays when installation is completed. Remove the CD-ROM and click
[OK].
5. After restarting, Windows NT will start up first, and then the application software will start
up (if correctly installed). If the installation has failed, repeat the installation from the
beginning.
6.System Installation
and Upgrade SYS-CP842-1.1E
216 CP-842E / CP-842ME System Reference
6.2 System Upgrades
Machine control software version upgrades are performed using the application CD-ROM.
Be sure to follow the procedure described below.
Note: This procedure is the same as that carried out in 1.3 Installing the Machine Control Software, except
that it does not continue on from the operating system installation.
1. With the machine power on, insert the application CD-ROM into the CD-ROM drive, then
turn the power off.
2. Turn the machine power on again. After Windows NT starts up, a Yes/No confirmation
message displays asking whether a version upgrade is to occur. Click [Yes] to
automatically begin the version upgrade processing.
3. When the control software upgrade is complete, a message displays requesting the
removal of the CD-ROM from the drive. Remove the CD-ROM and [OK].
4. Following rebooting (restart), the machine starts up with the upgraded system.