SYS-CP842-1.1E.pdf - 第39页
2.The Machine SYS-CP842-1.1E 30 CP-842E / CP-842ME System Reference MEMO:
SYS-CP842-1.1E 2.The Machine
CP-842E / CP-842ME System Reference 29
assembly is complete.
nozzle holder
A nozzle holder is attached to the end of each of the sixteen placing heads on the turret.
Each nozzle holder can hold up to six different nozzles (see also turret).
Pallet Change Unit (PCU)
Trolley style device used to transfer device pallets on and off the machine.
production program
The operating instructions that enable the machine to assemble all, or a specified portion
of the panel. In Fujis host system FujiCam, a production program is referred to as a recipe.
recovery
The action of reexecuting a pick-up sequence which was not successfully performed at the
previous attempt. The number of recovery attempts and the mode of recovery are user
specified.
skip mark
A mark on the panel which makes it possible to prevent the machine from placing parts on
a specific board of a multiboard panel. If the machine detects a skip mark at the specified
position on the board, it knows assembly for that board is not required.
touch screen
The interface on the machine which allows the operator to execute the machine commands
by touching the appropriate button on the screen.
XY-table
The main conveyor onto which the panel(s) is loaded during assembly.
virtual keyboard
This is a keyboard which displays on the touch screen. It is used to enter passwords, etc.
2.The Machine SYS-CP842-1.1E
30 CP-842E / CP-842ME System Reference
MEMO:
SYS-CP842-1.1E 3.Machine System
CP-842E / CP-842ME System Reference 31
3. Machine System
This part explains the machine functions accessed using the touch screen, and how to use
them.
3.1 Basic Operation
The machine and its functions are controlled by means of the command hierarchy operated
using the touch panel. This chapter explains the functions operated using the touch panel
and how to use them. The [Main] screen shown below is where all operation of the machine
begins. This screen displays after the machine is started up and the operator has logged
on to the system.