SYS-CP842-1.1E.pdf - 第226页

SYS-CP842-1.1E 6.System Installation and Upgrade CP-842E / CP-842ME System Reference 217 6.3 Installing the ID Tool License Upgrade CD The procedure of upgr ading Vision Tools is ex plaine d, which is necessary to pe rfo…

6.System Installation

and Upgrade SYS-CP842-1.1E

216 CP-842E / CP-842ME System Reference

6.2 System Upgrades

Machine control software version upgrades are performed using the application CD-ROM.

Be sure to follow the procedure described below.

Note: This procedure is the same as that carried out in 1.3 Installing the Machine Control Software, except

that it does not continue on from the operating system installation.

1. With the machine power on, insert the application CD-ROM into the CD-ROM drive, then

turn the power off.

2. Turn the machine power on again. After Windows NT starts up, a Yes/No confirmation

message displays asking whether a version upgrade is to occur. Click [Yes] to

automatically begin the version upgrade processing.

3. When the control software upgrade is complete, a message displays requesting the

removal of the CD-ROM from the drive. Remove the CD-ROM and [OK].

4. Following rebooting (restart), the machine starts up with the upgraded system.

SYS-CP842-1.1E 6.System Installation

and Upgrade

CP-842E / CP-842ME System Reference 217

6.3 Installing the ID Tool License Upgrade CD

The procedure of upgrading Vision Tools is explained, which is necessary to perform the

panel ID reading.

1. Insert the license key upgrade CD-ROM into the CD-ROM drive.

2. Press the [Info.] button at the CCD monitor.

3. Press the [Upgrade Vision Tools] button at the [Vision Tool Info.] dialog box.

6.System Installation

and Upgrade SYS-CP842-1.1E

218 CP-842E / CP-842ME System Reference

4. Press the [Upgrade] button at the [Vision Tool Upgrade] dialog box.

5. Verify that the IDTool item has been added to the [Enable Tools] list in the [Vision Tool

Upgrade] dialog box.