FlexTRAK 2MB Material Handler Addendum Rev 05.pdf - 第105页
© 2023 Nordson Corporation 6-1 6 Operatio ns 6.1 Overview FlexTRAK-2 MB System operations can beg in only after the 2MB material handle r axis positions are taught, the in itial start-up procedure is performed, an d the …
FlexTRAK Series 2MB Material Handler Addendum Tour of HMI Software for the Material Handler
5-38 © 2023 Nordson Corporation
Figure 5-18 Variable Snapshot Screen
Table 5-19 Variable Snapshot Screen Controls and Indicators
Control Description
SNAPSHOT DESCRIPTION Touch to enter a description for the snapshot.
OK Touch OK to create a snapshot with the above description.
© 2023 Nordson Corporation 6-1
6 Operations
6.1 Overview
FlexTRAK-2MB System operations can begin only after the 2MB material handler axis positions are
taught, the initial start-up procedure is performed, and the process recipes are properly programmed and
loaded by trained engineering personnel.
For more information about teaching material handler axis positions, see Section 7 Teaching Axis
Positions. For more information about recipes, refer to the FlexTRAK Installation, Operation, and
Maintenance Manual. For information on the FlexTRAK plasma module HMI screens refer to the HMI
Software User Guide.
This section covers the following basic operating information:
q
Stopping The Material Handler
q
Manual Mode
q
System Start
-
up
q
Resetting the Number of Cycles
q
Material Handler Homing Routine
q
Reinitializing System Parameters
q
Automatic (Auto) Mode
6.2 Safety First
Before operating your FlexTRAK-2MB System, see Section 2 - Safety.
WARNING! To prevent exposure to high voltages, RF energy, hot surfaces,
and moving parts, always make sure that all doors are closed and all access
panels are secured.
FlexTRAK Series 2MB Material Handler Addendum Operations
6-2 © 2023 Nordson Corporation
6.3 Stopping The Material Handler
6.3.1 E-STOP
To immediately stop all movement of the material handler, press the E-STOP button (Figure 6-1). This
method can be used during both Automatic and Manual modes.
6.3.2 Emergency Off
In an emergency, push the red EMO button on your plasma system to completely shut off power. This
method can be used during both Automatic and Manual modes.
?
NOTE Using the EMO button will completely turn off power to the plasma system. The system
will have to be restarted.
Item Description
1 EMO Button
2 E-Stop Button (EMERGENCY STOP)
Figure 6-1 E-STOP and EMO Locations
1
1
1
2