FlexTRAK 2MB Material Handler Addendum Rev 05.pdf - 第25页
FlexTRAK Series 2MB Mater ial Handler Adden dum Safety © 2023 Nordson Corporation 2-11 2.9 Basic Safety Precautions When used properly, the Fl exTRAK-2MB System provides safe and reliable service. The purpose of this adv…
FlexTRAK Series 2MB Material Handler Addendum Safety
2-10 © 2023 Nordson Corporation
Item Description
1 Hazardous Voltage
2 Moving Parts Warning
3 Arc Flash Potential
4 Forklift Point
5 Seismic Tie Down
Figure 2-4 Safety Hazard Labels (Rear View)
1
2
1
2
3
4
5
4
5
FlexTRAK Series 2MB Material Handler Addendum Safety
© 2023 Nordson Corporation 2-11
2.9 Basic Safety Precautions
When used properly, the FlexTRAK-2MB System provides safe and reliable service. The purpose of this
advisory is to point out possible hazards that may be encountered during operation, maintenance, and
servicing of your system.
WARNING!
Only qualified personnel should perform equipment installation, setup,
maintenance, troubleshooting, and repair.
2.9.1 Electrical Hazards
WARNING!
Always disconnect the equipment from the power source and attach a lockout
device to the electrical disconnect before performing any maintenance or repair.
2.9.2
22B22B
Mechanical Hazards
CAUTION!
Make sure both the in-feed and out-feed conveyor openings are covered prior to
operation of the system. When the FlexTRAK-2MB system is in line with other
machines, the conveyor openings are covered by those machines. However, if the
FlexTRAK-2MB is used as a stand-alone system, it is the system owner’s
responsibility to cover the conveyor openings to protect against injury to
personnel. Contact Technical Support to ask about optional conveyor covers.
2.9.3
23B23B
Thermal Hazards
CAUTION!
The reaction chamber, vacuum pump, and RF tuning network can become very
hot during system operation. If working near or around these areas, use
appropriate personal protective equipment to prevent burns.
2.9.4
24B24B
Environmental Hazards
2.9.4.1 Hazardous Waste
CAUTION!
Liquid wastes (e.g., sodium hydroxide, isopropyl alcohol) and solid wastes (e.g.,
electronic parts, chamber deposits, and dirty rags) generated during system
maintenance and servicing should be considered hazardous waste. Consult with
your facility safety officer and the manufacturer’s Material Safety Data Sheet for
instructions concerning proper disposal of hazardous materials. Contact
Technical Support if you have any questions.
FlexTRAK Series 2MB Material Handler Addendum Safety
2-12 © 2023 Nordson Corporation
2.9.4.2 Process Exhaust
CAUTION!
Exhaust discharge hazards are dependent upon the process gas(es) used and the
material(s) being treated. The chemistry of exhaust discharges should be
evaluated for potential hazards by trained safety/environmental engineers prior to
system start-up. Contact Technical Support if you have any questions.
2.9.4.3 Smoke from Electrical Fault
CAUTION!
Smoke generated by electrical faults inside the FlexTRAK system will be
exhausted into the surrounding area. Personnel should avoid inhaling the smoke
because it contains hazardous substances.
The chemistry of the smoke should be evaluated by trained safety/environmental
engineers for potential hazards prior to system start-up. Contact Technical
Support if you have any questions.
2.9.4.4 Electrostatic Discharge (ESD)
CAUTION!
Electrostatic discharge can damage or destroy semiconductors and other circuit
components. Use ESD preventive measures such as grounding wrist straps
whenever working near ESD-sensitive components.