FlexTRAK 2MB Material Handler Addendum Rev 05.pdf - 第35页
FlexTRAK Series 2MB Mater ial Handler Adden dum Installation © 2023 Nordson Corporation 3-3 3.4 Unpacking and Storing the System 3.4.1 Unpa cking the System WARNING! Crated eq uipment should be moved with a forklift to r…
FlexTRAK Series 2MB Material Handler Addendum Installation
3-2 © 2023 Nordson Corporation
3.3 Facility Requirements
To ensure optimal performance and safety, it is necessary to install the plasma system in a facility that
meets or exceeds the requirements listed in the FlexTRAK Installation, Operation, and Maintenance
Manual. If you have any questions about facility requirements, please contact Technical Support.
Figure 3-1 shows the recommended working allowances for the FlexTRAK-2MB plasma system.
Figure 3-1 Recommended Working Allowances
FlexTRAK Series 2MB Material Handler Addendum Installation
© 2023 Nordson Corporation 3-3
3.4 Unpacking and Storing the System
3.4.1 Unpacking the System
WARNING! Crated equipment should be moved with a forklift to reduce the
potential for injury.
CAUTION! Many system components are heavy. Use proper lifting and
moving procedures to avoid serious injury.
When the FlexTRAK-2MB System arrives at your facility, we recommend that you perform the
following procedure to ensure it has arrived in good condition.
To unpack the system:
1. Before opening the shipping crate, visually inspect it for damage.
„ Make note of any damage found and immediately report it to the shipping company.
2. Carefully remove the shipping crate and all interior and exterior packaging material.
Visually inspect the main plasma unit and all other system components for any damage.
„ Immediately report any damage found to Technical Support.
„ Keep all shipping containers and materials in case it should be necessary to return any
item to Nordson.
3. Using the included packing list, check to ensure that all listed components have arrived at
your facility.
„ Immediately report any missing or damaged items to Technical Support.
?
NOTE Claims based on late notification of shipping damage will be denied.
FlexTRAK Series 2MB Material Handler Addendum Installation
3-4 © 2023 Nordson Corporation
3.4.2
33B33B
Storing the System
If the FlexTRAK-2MB System is to be placed in long-term storage, place all system components in
protective packaging. A desiccant should be placed in the packaging to minimize moisture exposure.
Store components in a room with humidity of less than 80 percent.
To pack for long-term storage:
1. Fill the pump reservoir with oil to the proper level.
2. Run the pump for five minutes to lubricate the seals.
3. Remove all water from the cooling system.
4. Purge all gas lines and the chamber.
DANGER! Certain process gases or liquids selected for use with this
equipment can cause fire or explosion. Do not expose equipment
to any ignition sources. Consult your safety officer and the
manufacturer’s SDS to ensure proper precautionary steps are
taken.
WARNING! Certain process gases selected for use with this equipment are
toxic and require special precautions. Consult your safety
officer and the manufacturer’s SDS to ensure proper
precautionary steps are taken.
5. Place the system components and the vacuum pump in protective packaging.
„ A desiccant should be placed in the packaging to minimize moisture exposure.
6. Store components in a room with a humidity level of less than 80 percent.
?
NOTE During the time the pump is stored, also run it for five minutes every three months to
keep the seals lubricated.