Spectrum+Operating+Manual.pdf - 第112页

在线预览 Spectrum+Operating+Manual.pdf PDF 文档。

S2-9XXX Series Dispensing System IOM Manual Calibration and Adjustment

6. Adjust the FCVs as follows:

a. Adjust FCVs with the black hose for upward speed.

b. Adjust FCVs with the blue hose for downward speed.

7. Close the dispensing area door and toggle the lift output buttons to test the speed.

8. Repeat Step 6 and Step 7 until you are satisfied with the lift table operation.

9. When done, exit conveyor setup and return to the Fluidmove Main window.

Figure 5-38 Pre-Dispense Lift Table Controls

Figure 5-39 Post-Dispense Lift Table Controls

Figure 5-40 Dispense Lift Table Controls

6 Maintenance

6.1 Overview

Following a routine maintenance schedule and procedures can prevent part degradation and ensure high

quality performance for every production run. This section covers the following topics:

• Routine Maintenance Procedures

• Removing and Installing the Axis Covers

• Replacing Consumables

• Lubricating the Cables and Linear Guides

• Draining the Water Trap

• Tensioning the Cables

• Verifying Interlock Functionality

• Adjusting the Linear Encoders

• Computer Battery Reset

• Tensioning the Conveyor Belts

WARNING! Maintenance procedures should be performed by trained personnel only.

6.2 Safety First

Operation of your dispensing system involves heat, air pressure, electrical power, mechanical devices,

and the use of hazardous materials. Read this manual in its entirety before attempting any system or

component operation. It is essential for all personnel working on or around the dispensing system to fully

understand the hazards, risks, and safety precautions associated with operating the system. When properly

operated and maintained, the dispensing system is safe and reliable. See Section 2 - Safety for additional

information.

WARNING! Consult the Safety Data Sheet (SDS) for all fluids used with the dispensing

system. The SDS provides material usage instructions, disposal instructions, and

safety precautions.

WARNING! If the dispensing system is equipped with a ventilation system, make sure the

dispensing system ventilation is ON during handling and cleanup of all materials

used with the dispensing system.

6.3 Record Keeping

The type of maintenance performed (such as preventive and parts replacement) should be recorded in

maintenance records for the dispensing system. Dates, part numbers/serial numbers of replaced parts,

names of technicians, and other pertinent data should be recorded.