Spectrum+Operating+Manual.pdf - 第62页

S2-9 XX X Se ri es Disp ensi n g Syst em IOM Man ual Installation 3-10 © 2023 Nordson Corporatio n 3.9 Inst alling the Light Beacon 1. R em o ve the light beac on from th e storage area behi nd the front door panel and u…

100%1 / 222
S2-9XXX Series Dispensing System IOM Manual Installation
© 2023 Nordson Corporation 3-9
4. Place the purge station cup inside of the purge station (Figure 3-8).
5. Replace the purge station cover.
Item
Description
1
Purge Station Cover
2
Purge Station Cup
3
Purge Station
Figure 3-8 Purge Station
1
2
3
S2-9XXX Series Dispensing System IOM Manual Installation
3-10 © 2023 Nordson Corporation
3.9 Installing the Light Beacon
1. Remove the light beacon from the storage area behind the front door panel and unwrap.
2. Remove the dispensing system top cover (Figure 3-9A).
3. Attach the light beacon to the top panel using the four (4) screws temporarily installed
(Figure 3-9A).
4. Make the beacon electrical connection to J24 on the main board (Figure 3-9B).
Figure 3-9A
Figure 3-9B
Item Description
1 Light Beacon
2
Screws (4)
3 Beacon Electrical Connection
Figure 3-9 Installing the Light Beacon
1
2
3
S2-9XXX Series Dispensing System IOM Manual Installation
© 2023 Nordson Corporation 3-11
3.10 Installing the Laptop Computer
NOTE The laptop computer is shipped from the factory fully charged.
To install the laptop computer:
1. Remove the laptop computer from its packaging.
2. Remove the keys from the lock and give them to the person responsible for the machine.
The keys are used to lock the laptop computer to the dispensing system tray.
3. Power on the laptop computer.
4. Open Windows Explorer.
5. Follow the steps below to verify the serial number of the dispensing system and the laptop
computer are the same.
a. Locate C:\Asymtek\Recovery\SNXXXXX.ACL.
b. Compare the serial number located in the name of the ACL file with the serial number
on the dispensing system (Figure 3-10). If the numbers are not the same, contact
Asymtek Technical Support.
Item
Description
1
Serial Number Label
Figure 3-10 Dispensing System Serial Number Label
6. Power off the laptop computer.
7. Move the laptop tray arm bracket on the dispensing system so that the laptop tray is facing
forward (Figure 3-11).
8. Attach the USB and network cables and grounding wire attachment to their respective ports
on the computer.
1