Spectrum+Operating+Manual.pdf - 第79页
S2-9 XXX Se ri es Dispensing Sys te m IOM Man ual Calibration and Adjustme nt © 2023 Nordson C orporatio n 5-3 8. For rough foc us, per form the follo wing s teps: a. Hold th e camera and use a 3 mm hex key to loosen the…
S2-9XXX Series Dispensing System IOM Manual Calibration and Adjustment
5-2 © 2023 Nordson Corporation
5.4 Focusing the Camera
NOTE This procedure assumes the dispensing system has been powered on, Fluidmove is
running, and a representative substrate is available to teach the focal plane.
Tools and Materials Needed:
• 3 mm hex key
To focus the camera:
1. In the Fluidmove Programming Window, click the
Load a Board icon.
The conveyor will transport the substrate to the dispense station and the lift mechanism
will lift it off the conveyor belt. This establishes the focal plane.
2. In the Fluidmove Main Window, click on
Jog.
The Jog Window opens.
Refer to the Fluidmove User Guide or Fluidmove Online Help
for the Jog Window operation.
3. Click on
Video.
The Video Window opens.
4. Position the camera over a fiducial or an easily recognized feature on the substrate.
5. Loosen the locking ring on the camera lens (Figure 5-1).
6. Turn the middle section of the camera lens, clockwise or counterclockwise, until the middle
of the range of travel is reached. This will allow for fine focus after the camera is adjusted
for rough focus.
7. Tighten the locking ring.
Item Description
1 Locking Ring
2 Middle Section
Figure 5-1 Focusing the Camera
1
2
S2-9XXX Series Dispensing System IOM Manual Calibration and Adjustment
© 2023 Nordson Corporation 5-3
8. For rough focus, perform the following steps:
a. Hold the camera and use a 3 mm hex key to loosen the three (3) screws securing the
camera to the bracket (Figure 5-2).
b. Slowly move the camera up and down in the bracket.
c. When a sharp image is obtained in the Video Window, hold the camera and tighten the
three (3) screws securing the camera to the bracket using a 3 mm hex key.
Item
Description
1
Bracket
2
Screw (Third screw is located opposite of lower left screw)
3
Camera (Item 55)
Figure 5-2 Rough Focus
1
3
x3
2
S2-9XXX Series Dispensing System IOM Manual Calibration and Adjustment
5-4 © 2023 Nordson Corporation
9. For fine focus using the lens focus adjustment, perform the following steps:
a. Loosen the locking ring on the camera lens.
b. Turn the middle section of the camera lens, clockwise or counterclockwise, until a
sharp image is obtained in the Video Window.
c. Tighten the locking ring to lock the focus.
10. Perform camera calibration, see 5.5 Calibrating the Camera.
11. Adjust the lighting and color levels.
Refer to the Fluidmove User Guide or Fluidmove
Online Help
for adjusting the lighting and color levels.
12. Perform machine offset procedures.
Refer to the Fluidmove User Guide or Fluidmove
Online Help
to perform the offset procedures.
Item Description
1 Locking Ring
2 Middle Section
Figure 5-3 Additional Adjustments
1
2