Spectrum+Operating+Manual.pdf - 第30页
S2-9 XX X Se ri es Disp ensi n g Syst em IOM Man ual Introductio n 1-20 © 2023 Nordson Corpor ation Figure 1- 14 B Rear View Open ( S2 - 9XXP with Pr e - Queue and Po st - Queue Stations) It em Name Descript ion 1 Upper …
S2-9XXX Series Dispensing System IOM Manual Introduction
© 2023 Nordson Corporation 1-19
1.9.8 Rear View Open
Figure 1-13A S2-9XXX Rear View Open
1
2
3
4
S2-9XXX Series Dispensing System IOM Manual Introduction
1-20 © 2023 Nordson Corporation
Figure 1-14B Rear View Open (S2-9XXP with Pre-Queue and Post-Queue Stations)
Item
Name
Description
1 Upper E-Pan
The Upper E-Pan houses the dispense head controller, Z-axis servo amp,
and applicator pneumatics.
2 Lower E-Pan
The Lower E-Pan houses the main PWA, X-Y axis servo amps, main air
pneumatic valves, and conveyor pneumatic valves.
3
Rear Cabinet
See 1.11.9 Rear Cabinet.
4
Rear Panel
Connections
See 1.11.10 Rear Panel Connections.
Figure 1-15 Rear View Open
1
3
4
2
S2-9XXX Series Dispensing System IOM Manual Introduction
© 2023 Nordson Corporation 1-21
1.9.9 Rear Cabinet
Item
Name
Description
1
Conveyor/Heater
Module
(systems with heat)
Controls all conveyor functions (motors, sensors, pneumatics, etc.). It
receives power from the power manager and supplies AC power to the
substrate heaters in the dispensing area. If your system is equipped
with dual conveyors, there will be two Conveyor/Heater Modules. Note:
if the system does not have heat, it will have a conveyor controller
instead of a Conveyor/Heater Module.
2
Power Manager
(30A shown)
The Power Manager is located inside the rear cabinet. It houses the
main circuit breaker and the main power inlet. It also contains the EMO
circuitry. The EMO buttons, the green ON (I) button, and the black
OFF
(
0
) button are directly connected to the Power Manager.
Figure 1-16 Rear Cabinet
2
1