3OM-1050-002.pdf - 第239页

Fig. 3E1 1-1 Fig. 3E1 1-2 3.2 "Device Offset" T ab *7 *8 *10 *9 *1 1 *12 *13 *14 0307-002 5- 1 1-1 AFO01EDTP

3.2 "Device Offset" Tab

This session describes how to set various kinds of offset data for each

device position adjustment related to machine operation, for the cam-

era system related to placement accuracy, for the heads, and for the

nozzles.

CAUTION

Do not change the parameters unless necessary.

These parameters are factory-adjusted upon shipment

of the machine.

• Some parameters are automatically calculated through teaching op-

erations.

3.2.1 "Device Offset" Tab

• Sheet Layout

When the "Device Offset" tab is pressed in the "Device Offset" tab sheet,

the following tab sheet appears.

Fig. 3E11 "Device Offset" Tab Sheet

0301-005 5-11 AFO01EDTP

3.2 "Device Offset" Tab

Fig. 3E11-1

Fig. 3E11-2

3.2 "Device Offset" Tab

*10

*11

*12

*13

*14

0307-002 5-1 1-1 AFO01EDTP

• Sheet Composition

*1 X/Y table X [mm] (Horizontal), Y [mm] (Vertical)

This is the offset data between the X/Y table origin and the positional

reference of the head’s component placement.

When the X/Y table is at its origin, the distance between the P.C.B.

origin and the positional reference (reference head position) for com-

ponent placement performed by a nozzle on the #1 head should be

set to adjust the data compared with the design values.

Fig. 3E12

0307-006 5-12

AFO01EDTP

Head Placement Positional Reference

Rotary Turret

P.C.B.

P.C.B. Origin

(TCM-X200 TCM-X300)

P.C.B. Origin

(TCM-X100)

3.2 "Device Offset" Tab