3OM-1050-002.pdf - 第254页
0207-004 5 - 2 6 AFO01EDTP 3.2.4 "Feeder-A" and "Feeder-B" T abs • "Feeder-A" This is the offset data used to correct variation in each feeder slot No. (Fdr . No.) of the feeder carriages. T…
0207-004 5-25 AFO01EDTP
*3 High Mag X [mm], High Mag Y [mm], Low Mag X [mm], Low Mag
Y [mm]
The travel of the X/Y table is corrected according to the angle (0°,
90°, 180°, or 270°, 4 directions) specified in the placement data
when components are placed.
(a) The data input range is "-0.15 to +0.15 mm"
(b) When parameters with "+" sign are entered for both "X
[mm]" and "Y [mm]", they are added to the parameters
in the "X" and "Y" directions of the pattern program data.
(c) Change each parameter every time deviated compo-
nent position (X and Y) is found as a result of compo-
nent placement based on each placement angle data.
*4 Close Loop X [mm], Close Loop Y [mm]
(Not Available)
3.2 "Device Offset" Tab
0207-004 5-26 AFO01EDTP
3.2.4 "Feeder-A" and "Feeder-B" Tabs
• "Feeder-A"
This is the offset data used to correct variation in each feeder slot No.
(Fdr. No.) of the feeder carriages.
The parameters measured at shipment of the machine are en-
tered.
Do not change the parameters unless necessary.
• "Feeder-B"
This is the offset data used to correct variation in each feeder slot No.
(Fdr. No.) of the feeder carriages.
X [mm], Y [mm]
When the [Enable] buttons are selected for both "(X) Dir." and "(Y)
Dir." in the "Auto Fdr. Axis Set" group box (Operation Sequence:
"[OPN. MODE] Button on Submenu Bar" Æ "Opn. Mode" Tab
Sheet"), component recognition processing is performed during
automatic operation to track the positional relation between the
nozzle and component centers. After that, the parameters (X and
Y) are automatically updated for better pickup posture (pickup on
the component center).
In normal cases, it is not necessary to enter any parameter.
Parameters in "L [mm]" Text Boxes
These parameters are not updated automatically but the entered
ones are reflected.
3.2 "Device Offset" Tab
• Sheet Layout
When the "Feeder Carriage #1" tab is pressed in the "Feeder-A" tab
sheet, the following tab sheet appears.
(a) Follow the same procedure for the "Feeder-B" tab sheet.
(b) Follow the same procedure for the "Feeder Carriage #2",
"Feeder Carriage #3", and "Feeder Carriage #4" tab sheets.
Fig. 3E27 "Feeder Carriage" Tab Sheet
• Sheet Composition
*1 Feeder
The feeder Nos. (Fdr. Nos.) are displayed.
*2 X [mm]
Each text box shows an offset value of the X direction.
*3 Y [mm]
Each text box shows an offset value of the Y direction.
*4 L [mm]
Each text box shows an offset value of the L direction.
0301-006 5-27
AFO01EDTP
*1 *2
*3 *4
3.2 "Device Offset" Tab