3OM-1050-002.pdf - 第244页

0307-006 5- 16 AFO01EDTP *13 Support pin up/down [mm] This is the offset value indicating the dif ference between the P .C.B. thickness and the length of the support pin (actually measured value). *14 Unit P .C.B. B.B.R.…

*9 Feeder standby position

F1 [mm], F2A [mm], F3B [mm], F2B [mm], F3A [mm], F4 [mm],

Shown are the offset values (differences between the values of the

feeder standby position and the actually measured values of the

feeder axis origin position.

Fig. 3E16

*10 Input conveyor width [mm]

This is the offset value indicating the difference between P.C.B. Di-

mension Y and the actually measured conveyor width.

The actual value is measured after the conveyor width is

changed when the clearance data and device offset are

regarded as "0" (zero).

*11 Output conveyor width [mm]

This is the offset value indicating the difference between P.C.B. Di-

mension Y and the actually measured conveyor width.

The actual value is measured after the conveyor width is

changed when the clearance data and device offset are

regarded as "0" (zero).

*12 X/Y table chute width [mm]

This is the offset value indicating the difference between the chute

width of the X/Y table and the actually measured value.

(a) Measure the actual value at the P.C.B. outlet/input sec-

tions (fixed sections). Do not perform the measure-

ment at the roller position of the slide block.

(b) The actual value should be measured after the con-

veyor width is changed when the clearance data and

device offset are regarded as "0" (zero).

0307-006 5-15

AFO01EDTP

3.2 "Device Offset" Tab

(+)

(-)

0307-006 5-16 AFO01EDTP

*13 Support pin up/down [mm]

This is the offset value indicating the difference between the P.C.B.

thickness and the length of the support pin (actually measured value).

*14 Unit P.C.B. B.B.R.

X [mm], Y[mm]

This is the offset data used to correct the positional deviation of the

unit P.C.B. B.B.R. detection sensor.

X [mm] : Positional Correction Data in Horizontal Direction

Y [mm] : Positional Correction Data in Vertical Direction

3.2 "Device Offset" Tab

3.2.2 "Head" Tab

The "Head" tab sheet is composed of "Head Origin", "Head Offset", and

"Head Center Offset" tabs.

• Sheet Layout

When the "Head" tab is pressed in the "Device Offset" tab sheet, the

following tab sheet appears.

Fig. 3E17

• Sheet Composition

*1 "Head Origin" Tab

When selected, the "Head Origin" tab sheet appears.

*2 "Head Offset" Tab

When selected, the "Head Offset" tab sheet appears.

*3 "Head Center Offset" Tab

When selected, the "Head Center Offset" tab sheet appears.

0301-004 5-17

AFO01EDTP

3.2 "Device Offset" Tab