N7201A652E.pdf - 第127页
NPM- TT2 EJM1EE-MB-02 O-04 2-4-1 -2 Preparatio n 2 1 Installing the thin type single feeder Cut the carrier tape Attach the feeder to the attachment Align the feeder edge to the insertion slot of the dedicate d attachmen…
NPM-TT2 EJM1EE-MB-02O-04
Prepara-
tions
before
produc-
tion
Operating procedure
2-4-1
Preparation of the
intelligent feeder 1
2-4-1-1
2
1
Cut the carrier
tape
Attach the feeder to the feeder base
Align the end of the feeder with
a slot and insert it into the
feeder base.
3
Pull up the lever and push
it all the way inside.
Carrier tape
Attach the reels
■Large reel
Place the large reel on the
lower curved surface.
Make sure that the reel can rotate.
●Depending on the setting
condition of the adjacent
reel, install the separator.
●Use a spindle for a heavy
reel that does not rotate
smoothly.
( →P. 2-4-1-5)
■Small reel
Place the reel.
Raise the lever until it touches the lower
small reel guide.
●Pull the lever toward you and lower it to the
stopper.
2
1
1
2
1
2
1
2
2
1
Installing the double tape feeder
●About replacement of components(→P.3-3-1)
Describes how to install the double tape feeder and thin type single feeder.
(→[Intelligent tape feeder] operating manual)
The installation method of the intelligent stick feeder is the same as step ② below.
((→[ Intelligent Stick Feeder ] operating manual)
NPM-TT2 EJM1EE-MB-02O-04
2-4-1-2
Preparation
2
1
Installing the thin type single feeder
Cut the carrier
tape
Attach the feeder to the attachment
Align the feeder edge to the
insertion slot of the dedicated
attachment and insert.
Pull down the lever and insert it
all the way inside.
Confirm that the dedicated attachment has been installed.
2
1
●Refilling the substitution part (→P.3-3-1)
Carrier tape
To step on the left page
3
2
Align the attachment edge to
the slot and insert
Pull up the lever and insert
all the way inside
1
1
2
■How to attach the dedicated attachment
■How to attach the thin type single feeder
NPM-TT2 EJM1EE-MB-02O-04
Preparation of the
intelligent feeder 2
2-4-1-3
Operating procedure
2-4-1
Prepara-
tions
before
produc-
tion
Removing the double tape feeder
2
1
1
2
Lift up the rear
side and remove
the feeder with
both hands
Pull up the lever
and pull out the
feeder
How to hold the feeder
Hold the parts with
both hands
Using a preparation with production use feeders set to
the feeder cart allows you to exchange all feeders at once during production changeover. (→[Maintenance]
P.3-2)
Batch exchange using the feeder cart (option)
Pay attention to your surroundings when you move the feeder
cart
(Risk of injury in a collision with the cart )
WARNING
Describes how to remove the double tape feeder and thin type single feeder.
(→[ Intelligent Tape Feeder ] operating manual)
The removal method of the intelligent stick feeder is the same as the one of the double tape feeder.
(→[ Intelligent Stick Feeder] operating manual)