N7201A652E.pdf - 第242页
NPM- TT2 EJM1EE-MB -03O-02 3-3-4 Defective c omponents supplied from a tray fe eder are ejected to an eje ction pallet. If the ejection pallet is full and the nozzle picks up ejected compone nts during producti on, this …
NPM-TT2 EJM1EE-MB-03O-02
3-3-3
Compo-
nent
supply
31
5 4
2
6
7
8
Operating procedure
3-3-3
Tray replacement
(tray feeder)
Open the feeder
cover
Release the
clamp
Take out the
pallet
Replace the tray
Secure the tray
Return the pallet
back
Close the feeder
cover
Press the Feeder set
button
(The pallet moves back into the magazine)
Tray
Feeder set button
Feeder cover
Pallet
Clamp release lever
Clamp
When all components in the tray run out, replace it with the new components installed tray.
Clamp lever
Production
NPM-TT2 EJM1EE-MB-03O-02
3-3-4
Defective components supplied from a tray feeder are ejected to an ejection pallet.
If the ejection pallet is full and the nozzle picks up ejected components during production, this message
appears.
Compo-
nent
supply
Ejection pallet
Operating procedure
3-3-4
■If the ‘Setting’ of the item below is ‘ON’,
1
1
Confirm the message, and
perform any of the followings
A
A
A
A
Tray supply
(→P.5-1-1 ‘Option setting’)
■[Machine] - [Setting] - [Tray] - [Option] screen
■If the ‘Setting’ of the item below is ‘OFF’,
If the ejection pallet is full, it moves to the refill section: therefore you replace the
tray. (→P.3-3-3 ‘Tray replacement (tray feeder)’)
the ejection pallet is full, the machine stops in error; therefore you replace the
magazine.
(→P.2-4-2-5 ‘Removing the magazine from the tray feeder’)
4 Setting Change