Dek-265GSX-User-Manual.pdf.pdf - 第105页
STAGE 10 Running a Product in Run Mode 1. Select Setup (F6) Setup 2. Select Mode (F1) until Auto is indicated in the mode option on the screen. Mode 3. Select Exit (F8). Exit 4. Select Run (F1). If squeegees are being us…
STAGE 9
2Di Setup For a complete explanation of 2Di and its setup refer to the 2D Inspection
Chapter.
1.88 User Manual Software Version 6
MACHINE PROGRAMMING
STAGE 9
STAGE 10
Running a Product in Run Mode
1.
Select Setup (F6)
Setup
2.
Select Mode (F1) until Auto is indicated in the mode option on the screen.
Mode
3.
Select Exit (F8).
Exit
4.
Select Run (F1). If squeegees are being used continue with Step 5, if
ProFlow is being used go to Step 19.
Run
5. During the first print stroke, when the squeegee is down printing on the
board, select Stop Cycle (F2). The print cycle stops and the printer lid bolt
releases allowing access to the print carriage.
Stop
Cycle
6. Lift the front printhead cover.
7. Release the screws holding one paste deflector allowing it to drop into
contact with the screen.
Software Version 6 User Manual 1.89
MACHINE PROGRAMMING
STAGE 10
8. Insert a 0.25mm feeler between the deflector and the screen. Tighten the
screws checking that the 0.25mm gap remains.
9. Repeat Steps 7 and 8 for the other deflector.
10. Lower the front printhead cover.
11.
Press the System button.
12.
Select Continue (F1).
Continue
13.
Afterthesqueegeehasmovedapproximately20mm,selectStopCycle(F2).
Stop
Cycle
14. Lift the front printhead cover. Check the deflectors are not touching the
screen.
15. Lower the front printhead cover.
16.
Press the System button.
17.
Select Continue (F1).
Continue
18. Repeat Steps 5 - 17 for the other squeegee.
1.90 User Manual Software Version 6
MACHINE PROGRAMMING
STAGE 10