Dek-265GSX-User-Manual.pdf.pdf - 第35页

CAUTION SCREEN EXTRACTOR ROD. When the screen removal mechanism is being used and the extraction rod is extended (knob has been pulled forward), care should be taken not to bend the extraction rod by pushing it sideways …

STAGE 5B

Lt - Loading a

Screen

If a screen is already present in the printer this should be removed.

Press Change Screen (F5).

Change

Screen

2. When prompted to do so lift the printhead cover.

3. Slowly pull out the manual screen removal mechanism (black knob),

bringing the screen to the front of the machine. Do not pull too hard as this

may momentarily dislodge the chase.

1.18 User Manual Software Version 6

MACHINE PROGRAMMING

STAGE 5B

CAUTION

SCREEN EXTRACTOR ROD. When the screen removal mechanism is

being used and the extraction rod is extended (knob has been pulled

forward), care should be taken not to bend the extraction rod by pushing it

sidewaysor closingthefront cover. Distortionof the extractionrod impairs

the functioning of the screen removal mechanism.

ADJUSTABLE SCREEN SPACER. If an adjustable screen spacer has

been placed in the machine behind the screen, care should be taken when

removing the screen to avoid the spacer falling from the chase and causing

injury to the operator or damage to the machine.

4. If an Adjustable Screen Spacer is in the machine proceed to Step 5. Remove

the screen from the printer proceed to Step 9.

5. Pull the screen slowly forward until the rear edge of the screen, but NOT the

adjustable screen spacer, has just cleared the chase rails.

6. Lower the rear of the screen slightly so that it disengages from the adjustable

screen spacer.

7. Remove the screen from the machine.

8. Slowly remove the adjustable screen spacer from the machine.

Software Version 6 User Manual 1.19

MACHINE PROGRAMMING

STAGE 5B

9. If an Adjustable Screen Spacer is to be used proceed to Step 10.

Fit the new screen into the printhead ensuring the correct orientation of the

screen. For edge justified screen imagespushthescreenfullytotherear. For

centre justified screen images correctly position the screen using the

graduated scale. Proceed to Step 14.

NOTE

For the adjustable Screen Spacer setup, see Technical Reference Manual,

Screens and Screen Images Chapter.

10. Slide the adjustable screen spacer partly into the chase, with the jack screws

facing towards the rear of the machine.

11. Slide the screen into the chaseuntilitengageswiththescreencatch plates of

the adjustable screen spacer.

12. Slide the screen and spacer towards the rear of the chase until the spacer

makes contact with the chase stops.

13. Press gently against the front of the screen, to ensure that there is no gap

between the screen and spacer or the spacer and chase stops.

14. Lower the printhead cover.

1.20 User Manual Software Version 6

MACHINE PROGRAMMING

STAGE 5B