Dek-265GSX-User-Manual.pdf.pdf - 第372页
3. Select End Run (F1). End Run 4. Carry out Steps 19-33 of Prior to a Print Run procedure, earlier in this section. 5. Select Run (F1). The print run resumes. Run 6. If the set preference is set to pause, the following …
30.
Select Setup ProFlow (F4).
Setup
ProFlow
31.
Select Prime ProFlow (F6).
Prime
ProFlow
If it is possible to carry out the prime ProFlow function the message
‘Performing knead off-image.’ is displayed. If it is not possible the
function is deferred until it is, ie at the start of a print stroke with a board
loaded.
32.
Select Exit (F8).
Exit
33.
Select Exit (F8).
Exit
During a Print Run When the ProFlow cassette needs replenishment a warning window is
automatically displayed on themonitor. The warningwindow varies,depending
on the setting of the consumable action option in set preference.
If the set preference is set to warn, continue with Step 1. If the set preference is
set to pause go to Step 6. If the set preference is set to suspend go to Step 11.
1. If the set preference is set to warn, the following window is displayed:
The tricoloured beacon shows amber/green.
2.
Select Confirm (F1).
Confirm
Software Version 6 User Manual 9.57
CONSUMABLE REPLENISHMENTS
PROFLOW
3.
Select End Run (F1).
End
Run
4. Carry out Steps 19-33 of Prior to a Print Run procedure, earlier in this
section.
5.
Select Run (F1). The print run resumes.
Run
6. If the set preference is set to pause, the following window is displayed:
The tricoloured beacon shows red.
7.
Select Refill Paste (F1).
Refill
Paste
The message ‘Open the cover and change the ProFlow cassette.’ is
displayed.
8.
Select Open Cover (F2).
Open
Cover
9. Carry out Steps 19-33 of Prior to a Print Run procedure, earlier in this
section.
10.
Select Continue (F1). The print run resumes.
Continue
9.58 User Manual Software Version 6
CONSUMABLE REPLENISHMENTS
PROFLOW
11. If the set preference is set to suspend, the following window is displayed:
The tricoloured beacon shows red.
12.
Select Refill Paste (F1).
Refill
Paste
The message ‘Open the cover and change the ProFlow cassette.’ is
displayed.
13.
Select Open Cover (F2).
Open
Cover
14. Carry out Steps 19-33 of Prior to a Print Run procedure, earlier in this
section.
15.
Select Continue (F1). The print run resumes.
Continue
Paste
Retention System
Replacement
Due to wear over prolonged periods, it is necessary to replace the wiper foils and
end retainers (skis). An obvious indication of blade deterioration is print
medium left deposited on the screen after a print cycle.
Replace the wiper foils and end retainers (skis) as follows:
Software Version 6 User Manual 9.59
CONSUMABLE REPLENISHMENTS
PROFLOW
WARNING
SOLDERPASTEANDSOLVENTS. WHENUSINGORHANDLINGAN
Y
SOLDER PASTE OR SOLVENT FORMULATION THE
MANUFACTURERS' RECOMMENDED SAFETY PRECAUTIONS
MUSTBESTRICTLYADHEREDTO.
WARNING
PROTECTIVE CLOTHING. APPROVED PROTECTIVE CLOTHIN
G
SHOULD BE WORN BY SOLDER PASTEAND SOLVENT HANDLERS
AT ALL TIMES TO ELIMINATE FUME INHALATION, EYE
CONTACT,SKINCONTACTANDINGESTION.