Dek-265GSX-User-Manual.pdf.pdf - 第45页

31. Press the System button. 32. Select Exit (F8). Exit 33. Go to Stage 7. Software Version 6 User Manual 1.29 MACHINE PROGRAMMING STAGE 6A

100%1 / 388
25.
Select Raise Head (F2).
Raise
Head
26. Raise the printhead using two button control. Fit the head prop.
27.
Select Board Clamps (F3), to open the clamps.
Board
Clamps
28. Remove the board from the rails.
29.
Select Head (F2).
Head
30. Remove the head prop. Lower the printhead using two button control.
1.28 User Manual Software Version 6
MACHINE PROGRAMMING
STAGE 6A
31.
Press the System button.
32.
Select Exit (F8).
Exit
33. Go to Stage 7.
Software Version 6 User Manual 1.29
MACHINE PROGRAMMING
STAGE 6A
STAGE 6B
Tooling Setup - Vacuum
CAUTION
BOARD CLAMPS. Care must be taken to ensure that the board clamps
are not damaged when removing or replacing tooling.
1.
Select Change Tooling (F6).
Change
Tooling
2.
Select Full Width (F5).
Full
Width
3.
Select Raise Head (F2).
Raise
Head
4. Raise the printhead using two button control. Fit the head prop.
1.30 User Manual Software Version 6
MACHINE PROGRAMMING
STAGE 6B
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN
WORKING IN THE TOOLING AREA OF THE MACHINE TO AVOID
INJURY. THE FOILS ON THE FRONTAND REAR BOARD CLAMPS
AREVERYSHARP.