Dek-265GSX-User-Manual.pdf.pdf - 第347页

18. Using the two button control, prime the paper ensuring it feeds correctly. 19. Remove the head support. Lower the printhead using two button control. 20. Press the System button. Software Version 6 User Manual 9.33 C…

100%1 / 388
15. Rotate the take up roll one complete revolution against the motor clutch to
tension the cleaner paper across the cleaner squeegee assembly.
16. Ensure the cleaner paper has been routed correctly, from underneath the
paper roll (1) rearwards across the squeegee assembly and threaded between
paper rod and shaft (2).
NOTE
Figures in brackets refer to the diagram below.
17.
Press Prime Paper (F5) key.
The message ‘Press the two control buttons to feed paper’ is displayed.
Prime
Paper
9.32 User Manual Software Version 6
CONSUMABLE REPLENISHMENTS
BLUE UNDERSCREEN CLEANER
1
2
18. Using the two button control, prime the paper ensuring it feeds correctly.
19. Remove the head support. Lower the printhead using two button control.
20.
Press the System button.
Software Version 6 User Manual 9.33
CONSUMABLE REPLENISHMENTS
BLUE UNDERSCREEN CLEANER
VORTEX UNDERSCREEN CLEANER
Provision is made on the printer for automatic underscreen cleaning. This is
carried out using a cleaning cassette which contains a wet and dry cell. The wet
cell is impregnated with an appropriate solvent. A cleaning cycle consists of a
single return stroke incorporating a wet and dry wipe with or without vacuum.
The cleaning options can be programmed into a particular product file so that
they take place at preprogrammedintervals or they canbe selected,directly from
the MMI, to take place at the operators discretion.
Programming
Screen Clean
Operation into a
Product File
The screen clean parameters can be setup when editing a product file, while
setting up a new product. It may be more convenient to set these after the
product has been setup and printed and screen cleaning requirements have been
decided upon.
The parameters to be edited that affect the operation of the underscreen cleaner
are listed below with a definition of each as an aid to setup:
Parameter Definition
Front Start Offset The distance, in from the front edge of the board, at which the cleaner is to
finish.
Minimum -60mm
Maximum 60mm
Default 30mm
Increment 1mm
Rear Start Offset The distance, in from the rear edge of the board, at which the cleaner is to
start.
Minimum -60mm
Maximum 60mm
Default 30mm
Increment 1mm
9.34 User Manual Software Version 6
CONSUMABLE REPLENISHMENTS
VORTEX UNDERSCREEN CLEANER