Dek-265GSX-User-Manual.pdf.pdf - 第26页

5. Use either the Incr. and Decr. keys (F6 - F7) or the forward slash key (/) on the keyboard to change the parameter value. Incr. Decr. NOTE A definition of all editable parameters is contained at the end of this chapte…

100%1 / 388
STAGE 3
Editing a Product File
1.
Select Edit Data (F3).
Edit
Data
The Edit Current Process Parameters window is displayed:
2.
Select Incr. (F6). Type in required product name and press Enter using the
keyboard.
Incr.
3.
Highlight Product ID using theNextkey (F4). Select Incr. (F6). Typein the
required product ID and press Enter using the keyboard.
Next Incr.
4.
Use the Next and Previous keys (F4 - F5) to highlight the required
parameter.
Next Previous
Software Version 6 User Manual 1.9
MACHINE PROGRAMMING
STAGE 3
PRODUCT NAME
PRODUCT ID
DWELL HEIGHT
DWELL SPEED
SCREEN ADAPTOR
SCREEN IMAGE
CUSTOM SCREEN
BOARD WIDTH
BOARD LENGTH
BOARD THICKNESS
PRINT SPEED
FLOOD SPEED
PRINT FRONT LIMIT
PRINT REAR LIMIT
Dek04
Dek04
30
24
NONE
EDGE
DISABLED
101.5
152.5
1.6
150
20
0.0
0.0
mm
mm/s
mm
mm
mm
mm/s
mm/s
mm
mm
.. more
Edit Current Process Parameters
5.
Use either the Incr. and Decr. keys (F6 - F7) or the forward slash key (/) on
the keyboard to change the parameter value.
Incr. Decr.
NOTE
A definition of all editable parameters is contained at the end of this chapter.
6.
Select Save (F2). The message ‘Saving fiducial data - Please wait
Board data file saved’ is displayed.
Save
7. Repeat Steps 4 - 6 for the remaining parameters.
8.
Select Exit (F8).
Exit
1.10 User Manual Software Version 6
MACHINE PROGRAMMING
STAGE 3
STAGE 4A
Fit Squeegees
Fitting Squeegees If ProFlow was used when running the last product, carry out the ProFlow to
Squeegee Replacement Procedure, see Technical Reference Manual, Squeegee
Module Chapter - Replacement Procedures.
1.
Select Setup (F6).
Setup
2.
Select Setup Squeegee (F4).
Setup
Squeegee
3.
Select Change Squeegee (F1).
Change
Squeegee
4. Lift the front printhead cover.
5. Before fitting the squeegees to the machine, fix the paste deflectors to each
end of the squeegee assemblies, using the screws supplied. Ensure that the
bottom edge of the deflector is above the lower edge of the squeegee blade.
The setting of the paste deflectors is carried out later in this chapter.
NOTE
The deflectors are handed so care must be taken to fix the correct deflector to
each end of the squeegee assemblies.
Software Version 6 User Manual 1.11
MACHINE PROGRAMMING
STAGE 4A