00196608-01_AI_Stationaere_Kamera_Typ33_36_de_en.pdf - 第136页
Installation Installation on SX1/SX2 Machines Mechanical Assembly 136 Stationary Camera Type 33/36 Stationäre Kamera Typ 33/ 36 3.4.3 Mechanical Assembly Preparatory Steps ► Unhook the plate from the empty tape duct. ► I…
Installation
Installation position for SX1/SX2 Machines Installation on SX1/SX2 Machines
Stationary Camera Type 33/36 Stationäre Kamera Typ 33/36 135
3.4.2 Installation position for SX1/SX2 Machines
Installation position of camera in the SX1
1. IC camera
2. FC camera/3D coplan module
3. Component reject bin
Loc 1/2 = location 1/2
Installation position of camera in the SX2
1. IC camera
2. FC camera/3D coplan module
3. Component reject bin
Loc 1/2 = location 1/2
NOTICE
TwinHead
The FC camera and the 3D coplan module are only possible together with a TwinHead. Only
one of these options can be fitted at the same location, meaning that either the FC camera or
the 3D coplan module can be used.
Installation
Installation on SX1/SX2 Machines Mechanical Assembly
136 Stationary Camera Type 33/36 Stationäre Kamera Typ 33/36
3.4.3 Mechanical Assembly
Preparatory Steps
► Unhook the plate from the empty tape duct.
► If there is already a stationary FC camera present at the location, carefully pull the illumination unit
up and out and unhook the metal housing of the lower camera section.
Support plates
1. Support plate location 1
2. Support plate location 2
3. Holes for fixing screws to the machine frame (4x
DIN912-M6x12-A2-70)
FC = FC camera (type 25)
IC = IC camera (type 33)
1. Location 1
2. Location 2
3. Reject bins
4. FC camera (type 25) with fiducial plate
5. IC camera (type 33)
6. Support plate
Surface for screwing to machine lower section
1. Surface for screwed fixture of support plate (location
2 shown here)
Installation
Mechanical Assembly Installation on SX1/SX2 Machines
Stationary Camera Type 33/36 Stationäre Kamera Typ 33/36 137
Steel pins
See also
4.1 Installation Height of the Stationary Camera [ ➙ 153]
NOTICE
Support plates
If there is no stationary camera installed at location 1, you will need a "support plate assembly
SP1" [03070836-xx].
For location 2 you need the "support plate assembly SP2" [03070862-xx].
The cameras and reject bin are fitted onto this.
If not already present, you will need to knock two steel
pins [00311385-xx] into the support plate [03070836-xx].
► Carefully knock the steel pins into the two holes (1)
and (2) with the beveled side first. The steel pins
should protrude 8+/-1 mm out of the plate.