00198599-02_AI_Vacuumpump_X-Series-S-from-Hxxxx_DE_EN.pdf - 第170页
5 Converting to compressed air supply 170 Assembly Instructions / Montageanleitung SIPLACE X-Series S (from/ab Hxxxx) Option Vacuum Pump 02/2021
5 Converting to compressed air supply
Assembly Instructions / Montageanleitung SIPLACE X-Series S (from/ab Hxxxx) Option Vacuum Pump 02/2021 169
5 Converting to compressed air supply
Perform the following steps for a conversion from vacuum operation to compressed air operation.
For details, read the relevant installation chapters in this manual.
●
Converting the SIPLACE C&P20x
●
Dismantling the used tape chute
●
Removing the connector unit box
●
Replacing the cooling plate
●
Removing the exhaust air disposal
●
Removing the cap if required
●
Removing the exhaust duct
●
Removing the vacuum pump
●
Removing the supply cables
●
Rewiring the I/O distributor
●
Converting the hoses, installing the proportional controller, if required
●
Converting the gantries
●
Installing the used tape chute
5 Converting to compressed air supply
170 Assembly Instructions / Montageanleitung SIPLACE X-Series S (from/ab Hxxxx) Option Vacuum Pump 02/2021
6 Maintenance and service
Assembly Instructions / Montageanleitung SIPLACE X-Series S (from/ab Hxxxx) Option Vacuum Pump 02/2021 171
6 Maintenance and service
NOTICE
Observe the job cards and service manual
Read the following documents for maintaining the vacuum pump:
► Job cards for your machine (regular filter checks and replacement)
Vacuum filter F10 [03070370‑xx]
► Service manual for your machine (replacement of slide, when necessary)
Slide set [03077679‑xx]
See also
2 4.1 "Spare parts" [}167]