00197471-03_Service Manual Internal WPC5_6, EN_01-2019.pdf - 第145页
Service Manual In ternal WPC5 / WPC6 Page 5-145 5 W orking with the Adjustment Gauge for WPC 5.1 Preconditions: To move the Gauge o ver the switching po int of the „crash light barrier t ower“ (see 5.6 , it mus t be mo…
Service Manual Internal WPC5 / WPC6
Page 4-144
Restoring the machine data
➢ Log in as
Machine service
.
➢ Select
Sensors and Functions
(1) =>
Location
.
➢ Select the relevant location (2).
➢ Select the option
WPC Machine Data
(3).
➢ Enter the WPC serial number (4) and select
Accept
.
➢ Select
Restore machine data
(5).
⇨ A dialog box for the machine data storage location will open.
➢ Navigate to the required storage location and then restore the machine data.
Service Manual Internal WPC5 / WPC6
Page 5-145
5 Working with the Adjustment Gauge for WPC
5.1 Preconditions:
To move the Gauge over the switching point of the „crash light barrier tower“ (see
5.6
, it must be
moved with the lifting axis using an "invisible mode".
However, this mode only works with WPC firmware ≥ 3.01.
This is included in the following versions of the station software:
≥ SW 704.03 SP1 HF5.
≥ SW 705.04 SP1 HF5.
Before you start work, make sure that the WPC is using the correct firmware version.
5.1.1 Lifting axis in „Unsafe Mode“
WARNING
! Liftign Axis in „Unsafe Mode“ !
To the drive the lifting axis in step procedure, you need to activate the so-called “Unsafe
Mode”.
Only move the lifting axis with caution and only in small (manageable) steps!
NOTICE
Operation with Caccia
In order to obtain a better coverage of various set points, the WPC can also be taken out
oft he machine and the axis can be driven by CACCIA Software.
Service Manual Internal WPC5 / WPC6
Page 5-146
You are in the „Teach Assistent“ of the software.
⇨ Sensors and Functions ⇨ Location ⇨ Check Functions of WPC ⇨ Additional Functions ⇨ Lifting axis
selected ⇨ Move lifiting axis ⇨ Continue.
…… ⇨ Unsafe Mode wählen ⇨ Select Step size ⇨ move lift axis with arrow keys.
If you left the page with „Finish“, the „Unsafe Mode” is automatically ended and switchted back to
Safe Mode.