00197471-03_Service Manual Internal WPC5_6, EN_01-2019.pdf - 第167页
Service Manual In ternal WPC5 / WPC6 Page 5-167 5.7 Setting the de flector at the flap to the l oading axis 2 plastic deflectors are i nstalled at the protec tive flap between the tower a nd the non -stop m odule (load…
Service Manual Internal WPC5 / WPC6
Page 5-166
NOTICE
Position of the crash light barrier
When setting the light barrier, make sure that the positions of the transmitter and receiver
match. To do this, use a sliding gauge to measure the exact position of the front edge of
the tower cover with respect to the center of the screw on both sides. This gives the
rough position.
Adjustment of the final x/10 mm can then be done on one side.
Figure 5.29: Setting the crash light barrier at the transfer point to the feed axis
Figure 5.30: Setting the crash light barrier at the transfer point to the feed axis, right
Switching edge on the gauge
"Strip for crash light barrier, transfer
point, feed axis" [03093816-01]
Service Manual Internal WPC5 / WPC6
Page 5-167
5.7 Setting the deflector at the flap to the loading axis
2 plastic deflectors are installed at the protective flap between the tower and the non-stop module
(loading axis).
These deflectors are also used to align the waffle pack tray carriers in the tower.
Figure 5.31: Deflectors at the protective flap.
The gauge is still clamped in the tower in the position described above.
The protective flap is closed, i.e. in the top position.
To make this setting, attach the "Strip for stopper flap, complete" [03093815-xx] to the baseplate..
Figure 5.32: Base plate of the gauge with the deflector setting gauge attachment.
Service Manual Internal WPC5 / WPC6
Page 5-168
Now move the tower to the position at which the gauge with the attached "Strip for stopper flap,
complete" [03093815-xx]", is precisely in the setting range of the deflectors.
Move the gauge with the strip into the setting range of the deflectors.
Figure 5.33: Setting the deflectors on the safety flap.
Now set the gap to the deflector in such a way that the strip just touches the deflector.
Figure 5.34: Setting the deflectors on the safety flap.
Deflector lightly
touching the
bar.
Screws for
adjusting and
securing the
deflectors.
Setting range on
the deflector