00197783-01_AI_Gantry-Retrofit_X-Series_S_INTERNAL_de_en.pdf - 第105页
Installation 3.1.4 Removing the Top Cover Preparatory Steps Gantry Retrofit Portalnachrüstung 105 3.1.4 3 . 1 . 4 R e m o v in g t h e T o p C o v e r Removing the Top Cover For better access to the work area, we recomme…
Installation
Preparatory Steps 3.1.3 Removing the Middle Cover
104 Gantry Retrofit Portalnachrüstung
► Loosen the eight top screws (1) fastening the cover
(two on each side and four at the front).
► Lift off the top cover. Unplug the electrical connection,
while doing so.
Installation
3.1.4 Removing the Top Cover Preparatory Steps
Gantry Retrofit Portalnachrüstung 105
3.1.4
3.1.4 Removing the Top Cover
Removing the Top Cover
For better access to the work area, we recommend that you remove the top cover on the placement area.
► Unplug the connector (1) on the cover fan at both
sides.
► Loosen the eight screws fastening the cover (four on
each side) (1).
► Lift the cover up and off the machine.
Installation
Gantry 1/3: Removing the Y Trailing Cable and Trailing Interface 3.1.4 Removing the Top Cover
106 Gantry Retrofit Portalnachrüstung
3.2
3.2 Gantry 1/3: Removing the Y Trailing Cable and Trailing Interface
Gantry 1/3: Removing the Y Trailing Cable and Trailing Interface
NOTICE
Gantry 1 or 3
If a gantry is retrofitted in a placement area (PA), you will need to replace the long trailing cable
for the gantry already fitted with the shorter version. The trailing interface must also be moved.
This procedure is exactly the same for both PA1 and PA2.
NOTICE
Service manual
► Observe the relevant chapter in the service manual.
► Remove the screws (2) and dismantle the covers (1)
on the trailing interface boards in both placement ar-
eas.
► Unplug all pneumatic connections (blue, black and
white hoses) (2).
► Unplug all electrical connections (1) on the trailing in-
terface and Vision Hotlinik Adapter.
► Remove the long screw (3) with the Y pieces.
► Use a cable tie to bind all cables and hoses together.
► Loosen the three screws (1) fastening the bottom
holder on the Y trailing cable.
⇨ The lower end of the Y trailing cable has now been
completely disconnected from the machine.