00197783-01_AI_Gantry-Retrofit_X-Series_S_INTERNAL_de_en.pdf - 第112页
Installation Preparing the Cable and Hoses 3.1.4 Removing the Top Cove r 112 Gantry Retrofit Portalna chrüstung ► Shorten the white hoses on both sides, level w ith the large hole (1) . If possible, also shor ten white h…
Installation
3.1.4 Removing the Top Cover Preparing the Cable and Hoses
Gantry Retrofit Portalnachrüstung 111
► Remove the following from the bag: (1) connector
X6qa2 for gantry 2 - cable [03076477-xx] (for the Vi-
sion Hotlink Adapter voltage).
There are more openings in the middle of the machine
frame, directly above the conveyor.
► Pull out the two black hoses (1) with plugs here.
► Remove the two plugs. Keep the plugs. If there is no
vacuum pump fitted, these will be needed for the
back of the gantry.
► Extend the two black hoses with the white hoses (1).
► Pull the white hoses from above, downwards through
the machine frame, in order to connect them there.
Installation
Preparing the Cable and Hoses 3.1.4 Removing the Top Cover
112 Gantry Retrofit Portalnachrüstung
► Shorten the white hoses on both sides, level with the
large hole (1).
If possible, also shorten white hoses which have al-
ready been used. This removes any damaged sec-
tions of the hoses.
CAUTION!
Do not shorten the black hoses.
Installation
3.1.4 Removing the Top Cover Fitting the Trailing Interface Boards
Gantry Retrofit Portalnachrüstung 113
3.4
3.4 Fitting the Trailing Interface Boards
Fitting the Trailing Interface Boards
► Fit the third spacer bolt (1).
► Check whether the strain relief (1) for the hotlink ca-
ble (top right in the diagram) is present at all points.
► If required, add more strain relief (1x spacer bolt, 2x
washer and 1x plastic strain relief each). Secure the
strain relief with Loctite 241.
► Fit the two trailing interface boards (1) and the two Vi-
sion Hotlink Adapters (2), together with the assembly
plates (3).
Each assembly plate is fastened with an outer (4) and
a joint inner screw.
Make sure that the white hoses are run correctly (in
pairs on the left and right under the assembly plate).