00197783-01_AI_Gantry-Retrofit_X-Series_S_INTERNAL_de_en.pdf - 第117页
Installation 3.1.4 Removing the Top Cover Fitting the Gantry Gantry Retrofit Portalnachrüstung 117 3.5 3 . 5 F it t in g t h e G a n t r y Fitting the Gantry ► Rem ove the bu ffer holder a nd the plas tic covers (1) on b…
Installation
Fitting the Trailing Interface Boards 3.1.4 Removing the Top Cover
116 Gantry Retrofit Portalnachrüstung
The installation of the trailing interface and Vision Hotlink Adpater board, plus the pneumatic hoses, at
the machine end, has now been completed.
Trailing interface and Vision Hotlink Adapter fully installed
Installation
3.1.4 Removing the Top Cover Fitting the Gantry
Gantry Retrofit Portalnachrüstung 117
3.5
3.5 Fitting the Gantry
Fitting the Gantry
► Remove the buffer holder and the plastic covers (1)
on both rails.
► Loosen the 16 screws fastening the four trolleys to
the gantry. The four trolleys must then have room for
movement.
► Remove the protective foil (1) on the incremental en-
coder on the gantry.
When installing the gantry, you either need a gantry lift or
the help of a second person.
► Lift the gantry onto the guide rails.
► Position the gantry as exactly as possible and then
push it carefully onto the rails. This presses the plas-
tic sleeves in the trolley bearing out.
CAUTION!
Do not pull the gantry backwards. This could cause balls
to fall out of the trolley bearings.
Installation
Fitting the Gantry 3.1.4 Removing the Top Cover
118 Gantry Retrofit Portalnachrüstung
► Fit the buffer holder with the three fastening
screws (1). Make sure that this is exactly vertical.
Tighten the three fastening screws with a torque of
24.7 Nm.
► Fit the long buffer (1).
► Fit the two plastic covers on the ends of the guide
rails (2).
► Check the gap between the trolley and the guide rails.
This should be the same at all points.
► Tighten the 16 fastening screws (1) with a torque of
9.5 Nm.
Always tighten all four screws in the row. Start with
the top row and work your way downwards.
► Tighten the 16 fastening screws again to check them,
using a torque of 9.5 Nm.