SI-F130 Manual(EN)_jpg_ Rev1.pdf - 第47页
Parts Camera Back Light Calibration HLF-10304-01 Parts Camera Back Light Calibration SHEET 1/3 Part s Camera Back Light Calibration [Necessary jigs] • T ransmission nozzle jig • T ransmission brightness calibration jig […
45 degrees Parts Camera Light Calibration
HLF-10303-01
45 degrees Parts Camera Light
Calibration
SHEET
2/2
5 Press the START button on the operation
panel.
The turret No.1 moves to the recognition position.
6 Check the position if the Light Calibration jig
is within the recognition range of the PARTS
DISPLAY.
7 Re-press the START button on the operation
panel.
45 degrees parts camera light calibration is started.
After a few minutes, the calibration ends, and Lv1
values from level 1 to 8 and Gap value are displayed
on the 45° Parts Front Light screen.
8 Check the Gap values of Level 1 to 8.
It is normal if the Gap value is within 0 to 3.
9 Click the Save button.
The Gap values of Lvl 1 to 8 are saved and the 45°
Parts Front Light screen closes.
10 Remove the light calibration jig and nozzle jig (AF80400).
1. Close the Light Calibration screen and calibration screen.
2. Click in an order of MANUAL menuÎAXIS MOTION tabÎRT button.
3. Click the Jog Move button.
4. Jog move the turret No.1 toward you by pressing the left and right cursor keys to remove
the light calibration jig and nozzle jig (AF80400).
Parts Camera Back Light Calibration
HLF-10304-01
Parts Camera Back Light Calibration
SHEET
1/3
Parts Camera Back Light Calibration
[Necessary jigs]
• Transmission nozzle jig
• Transmission brightness calibration jig
[Procedure]
1 Display a Parts Back Light screen.
1. Click the Light Calibration button on
the CALIBRATION screen.
Light Calibration screen is displayed.
2. Click the Parts Back Light button on
the Light Calibration screen.
Parts Back Light screen is displayed.
Transmission brightness
calibration jig
Transmission
nozzle jig
Parts Camera Back Light Calibration
HLF-10304-01
Parts Camera Back Light Calibration
SHEET
2/3
2 Select jig No. of the transmission brightness
calibration jig (filter) from the list box.
3 Click the Calibration Start button and press
the START button on the operation panel.
The turret No.1 moves to the jig setup position.
4 Install the transmission nozzle jig to the tur-
ret No.1.
When installing the nozzle, insert it while
slowly turning.
After inserting the nozzle, check that it is
not drawn out by pulling downward.
5 Install the transmission brightness calibra-
tion jig to the parts camera.
Transmission
nozzle jig
Parts Camera
Transmission
brightness
calibration jig