MAN00000772_SI-G200BB_SVCPDFA.pdf - 第161页
HLGB-10103-01 Front, Rear LED Control PWB Setup Press the DA T A button for three seconds or l onger . Press the DA T A button to s elect lig ht to be setup. T o change the s ett i ng, press the UP/DOWN button to change …
HLGB-10103-01
Front, Rear LED Control PWB Setup
Press the MODEL button for three
seconds or longer.
Check that the LEDs light up at the
position shown in the Fig.
If the LED lighting-up state is
different, press the UP/DOWN switch
to change the lighting LED as shown
in the Fig.
When ending setup, wait until the
LED lights off.
Press the REF button for three
seconds or longer.
Press the REF button to select light to
be set up.
To change the setting, press the
UP/DOWN button to change so that
the camera setup LED lights up.
When ending setup, wait until the
LED lights off.
SI-G200BB
headREFvaluesetuplist
HLGB-10103-01
Front, Rear LED Control PWB Setup
Press the DATA button for three
seconds or longer.
Press the DATA button to select light
to be setup.
To change the setting, press the
UP/DOWN button to change so that
the camera setup LED lights up.
When ending setup, wait until the
LED lights off.
SI-G200BB
headlightsetupvaluelist
HLGB-10104-01
Change in User Level
To display a screen used for calibration, it is necessary to change user level. This section describes a
procedure to change user level.
[Procedure]
Click the button on the left
upper of the screen.
USER LEVEL screen is displayed.
Click the SERVICE button.
Enter the password and click the Set
button.
To display the calibration screen, it is necessary
to change the USER LEVEL to
[MAINTENANCE] or [SERVICE].