MAN00000772_SI-G200BB_SVCPDFA.pdf - 第173页
HLGB-10202-01 H A xis Origin Position Setup Click the H Axi s Hom e button on the Machine Setup screen. Click the XY button on the H Axis Home screen. Click the Jog Move button in the move mode. Press the cursor key to m…
HLGB-10202-01
H Axis Origin Position Setup
Perform this working on both heads on the front side and rear side.
[Necessary jigs]
Click in an order of M/C SETUP
menu M/C MAINTENANCE tab
Calibration button.
Click the Machine Setup button on the
CALIBRATION screen.
HLGB-10202-01
H Axis Origin Position Setup
Click the H Axis Home button on the
Machine Setup screen.
Click the XY button on the H Axis
Home screen.
Click the Jog Move button in the move
mode.
Press the cursor key to move the head
to a position where working is easily
performed.
Press the Return button after the
head moves to close the XY axis
screen.
HLGB-10202-01
H Axis Origin Position Setup
Click the Setup Start button on the H
Axis Home screen.
Press the [START] button on the
operation panel.
Lower the H axis roller by hand and
gradually return it to the top end.
After returning the H axis, push up the inner
shaft from lower section by finger and check
that the inner shaft has returned to the
uppermost end.
Press the [START] button on the
operation panel.
Repeat working of the procedure 2.-4.
up to the turret No.8.