MAN00000772_SI-G200BB_SVCPDFA.pdf - 第340页

HLGB-10416-01 Adjustment of PWB Sensor This section de s cribes a procedure to adjust sensitivity and installing position of PWB detecting sensor (BS54, BS50) . [Necessary jigs] • Do not Use jig. [Procedure]

HLGB-10415-01

Nozzle Sensor Adjustment

Remove the nozzle for production

installed on the turret No. 1.

Press the SET button again.

Set the mode set switch to RUN.

Check that the L/D set switch is set to

the D side.

Close the cover for the sensor.

NORM

TEACH

RUN

ADJ

ZONE

NEAR

FAR

HLGB-10416-01

Adjustment of PWB Sensor

This section describes a procedure to adjust sensitivity and installing position of PWB detecting

sensor (BS54, BS50).

[Necessary jigs]

• Do not Use jig.

[Procedure]

HLGB-10417-01

Adjustment of Cassette Float Sensor

Height

This section describes a procedure to adjust the height of the cassette float sensor by using feed

adjusting jig and cassette float sensor height adjusting jig.

[Necessary jigs]

• Feed adjusting Jig

• Cassette float sensor height adjusting Jig

[Procedure]

Set the replacing carrier on the unit.

Click in an order of MANUAL menu

 CASS. tab.

Click the Up button for the replacing

carrier on the front or rear side.

Press the [START] button on the

operation panel.