MAN00000772_SI-G200BB_SVCPDFA.pdf - 第355页

HLGB-10420-01 Area Sensor Optical Axis A dj ustment Cassette specification is d ifferent from tray specification in jig hole to be used. Holes on the front are fo r cassette specification and holes o n the back are for t…

HLGB-10420-01

Area Sensor Optical Axis Adjustment

Check that the replacing carrier has

been raised.

Set the optical axis adjustment jig on

the cassette table of supply No.101.

There should be no gap between the optical axis

adjustment jig and the cassette table.

Loosen the mounting bolts for the area

sensor to adjust up and downward

positions.

Loosen the cap screw on the lower side

of the bracket to adjust forward and

backward position of the area sensor.

HLGB-10420-01

Area Sensor Optical Axis Adjustment

Cassette specification is different from tray

specification in jig hole to be used.

Holes on the front are for cassette specification

and holes on the back are for tray specification

with the optical axis adjustment jig being placed

on the cassette table.

Remove the optical axis adjustment

jig.

Click in an order of MANUAL menu

 I/O tab  Serial I/O button 

Input tab.

When shielding the area sensor by

hand, check that the sensor is turned

OFF.

HLGB-10421-01

Ejector Setup

[Procedure]

Set four holes on the left side pulley

horizontally/vertically.

Move the pusher by hand so that the

pusher left face is at the ORG position.

Loosen the screws on the mounting

bracket for the ORG sensor.

Tighten the screws on the mounting

bracket to fix on a boundary where the

LED on the ORG sensor changes to

lighting off to lighting up.