MAN00000772_SI-G200BB_SVCPDFA.pdf - 第348页
HLGB-10419-01 Fixed Ca mera Pickup Check Sensor Adjustment Check that the displayed val ue on the sensor amplifier is “3800” or more. “ ” Loosen the sensor bracket mounting bolt, and move the sensor bracket up and down, …
HLGB-10419-01
Fixed Camera Pickup Check Sensor
Adjustment
Carry out working with care not to damage the
fiber cable for parts presence/absence detecting
sensor.
Open the cover for the sensor
amplifier.
Turn the SET/RUN selector switch to
SET.
Press the MODE button to select item
to be set.
Press the UP/DOWN button to change
the set button.
L D
HLGB-10419-01
Fixed Camera Pickup Check Sensor
Adjustment
Check that the displayed value on the
sensor amplifier is “3800” or more.
“ ”
Loosen the sensor bracket mounting
bolt, and move the sensor bracket up
and down, to left and right to adjust
the fiber sensor mounting position.
Loosen the set screw to adjust rotating
direction of the pickup check sensor.
Turn the emergency stop switch to
release emergency stop.
Click the [ORG] button to return the
system to the original position.
Click in an order of MANUAL menu
AXIS MOTION tab XY button.
HLGB-10419-01
Fixed Camera Pickup Check Sensor
Adjustment
Click the Jog Move button.
Press the cursor key and move the
center of the fixed camera jig nozzle to
cross point of the hair lines on the
PARTS DISPLAY screen.
After moving the head, click the
Return button to close the XY Axis
screen.
When performing this operation immediately
after auto calibration, absolute-move the head to
the position described
on#PbPointForFixedCam1 in Calibration.dat
using MANUAL/AXIS MOTION menu to adjust
fine position. More accurate position adjustment
will be possible.
Put “Fixed camera parts presence/absence
sensor adjustment jig“ on “Fixed camera
jig base“.