TR7500E_Manual_en_v28.pdf - 第65页
C h a p t e r 2 M a nu a l B a r i n t r o d u ce T R 7500 U S E R M A N U AL 58 C h a p t e r 2 M a n u a l B a r i n tr odu ce 1 . F il e C r e a t e a n e w A O I P r o j ec t f i l e O p e n AO I P r o j ec t f il e …
Chapter 1 AOI Standard Project Creation
TR7500 USER MANUAL
57
(7) After all FOVs are tuned well, press [Save pre.] to save the changed project.
(8) Press [Close&Stop] to close the result dialog.
(9) Choose [Operation/Confirm Mode] and press [Inspect] to inspect whole board by
real time images. And tune the failed images.
(10) Do the above actions for several different golden boards as the case may be until
the project is stable.
(11) Start to inspect.
Chapter 2 Manual Bar introduce
TR7500 USER MANUAL
58
Chapter 2 Manual Bar introduce
1. File
Create a new AOI Project file
Open AOI Project file
Save AOI Project file as another file name
Print format setting
Recent opening AOI file list
Log out the current user
Quit AOI inspection Program
2. View
Toolbars function display “ON” or “OFF”
Status Bar function “ON” or “OFF”
Inspection analysis for yield rate display
Display toolbars in operation system language
Display toolbars in English
3. Parameter
AOI on line link with repair station setting
System halt timing and fail signal output setting
Parameter setup for Panel
Reading 2D Barcode Function
Defines the serial code of the PCB
3.1. User mode
Transfer AOI data to Repair station
General operation mode for operator
Complete mode for engineer setting (Need
input Password)
Chapter 2 Manual Bar introduce
TR7500 USER MANUAL
59
3.1.1. Link to Repair Station?
l Check to deliver the after result data to repair station. If the communication
between computers is broken the data will be saved in [C:\AOI_Repair_Data]
folder. After the link is normal the data will be transferred to repair station
automatically.
3.1.2. Link to Offline Editor?
l Select this item to pass the result to Offline Editor. When you set [Offline=1] at
registry (it means that the machine is an Offline Editor), the item turns to display
[Link to Machine?]. See Chapter 8 for more information about Offline Editor.
3.1.3. Operator Mode/Engineer Mode
l You can choose [Operator Mode] or [Engineer Mode] to operate the project. The
beginning setting is the same as the previous setting. The user can’t edit the
project in [Operator Mode] they can open project or inspect only. The password
of choosing [Engineer Mode] is [7100].
3.2. System
3.2.1. Halt Machine when Repeat Fail
l When a component is failed for specific times, the motion of table will pause and
the project presents a warning dialog.
l Set test counts
l Warning dialog