YST15_Users_E.pdf - 第7页
iii Safety instructions Potential hazard Electrical shock hazard T o avoid hazard Do not touch while power is supplied. Applicable machines YST15 main control panel Case Maintenance Potential hazard Electrical shock haza…
ii
Safety instructions
1. Label positions
The following warning/caution labels are attached to the YAMAHA products to ensure safe and correct use.
Check that the information on each label is clearly legible and comply with the instructions.
For safety precautions other than those on the labels shown in this section, see the instructions in "2.Safety".
n
NOTE
Basically, labels are attached to the positions shown below, although they may differ slightly depending on the
machine model.
n
NOTE
When connecting power to this equipment, refer to "Power connection terminals" described in the appendix of the
maintenance manual or user's manual.
Warning/caution labels
■
Main control panel
■ Loading/Unloading area.
■ Loading/Unloading area.
93011-KMS-10
iii
Safety instructions
Potential
hazard
Electrical shock hazard
To avoid
hazard
Do not touch while power is supplied.
Applicable
machines
YST15 main control panel
Case
Maintenance
Potential
hazard
Electrical shock hazard
To avoid
hazard
Do not open this panel before turning off the power.
Applicable
machines
YST15 main control panel
Case
Maintenance
Potential
hazard
Hands or fingers might be pinched or crushed by front door, causing injury.
To avoid
hazard
Never place hands or fingers when closing the door.
Applicable
machines
YST15 front door inner side
Case
Setup
(Loading/Un-
loading)
iv
Safety instructions
2. Safety
To ensure that the machine you purchased is used safely and correctly, always comply with the instructions
and rules in this manual regarding safety. However this manual cannot cover all items regarding safety in
detail. So it is extremely important that the operator or person handling the machine make correct decisions
regarding safety.
2.1 To ensure safety
To maintain the safety of the operator or person working with this machine, it is essential that it (including
external parts feeders) be installed correctly in compliance with the safety standards and conditions of that
country.
Complying with the safety regulations and laws of that country is the responsibility of the customer who
purchased this machine. The supervisor of this machine must take responsibility to ensure all measures have
been taken for machine safety.
2.1.1 Defining safety
1. Safety has priority over all other operations.
2. Safety is more important than any other task.
3. Safety is the foundation for work efficiency.
4. Safety begins with maintaining (keeping it neat and orderly) the work environment.
2.1.2 Causes of injuries and accidents
Most accidents are not something that occurs but something that are caused. So it is important to make an
effort NOT to cause accidents.
n
Hazardous actions
• Ignoring causes of accidents
• Working or operating equipment in cramped locations
• Working in locations or positions where safety cannot be ensured
• Unsafe machine operation and using equipment whose safety cannot be ensured
• Working or operating equipment at speeds where safety cannot be ensured
• Working or operating machines with safety equipment removed
• Performing work or tasks on top of a machine currently in operation
• Playing around or goofing off during work
• Performing maintenance or inspections without wearing safety gear
2.2 Using safety gear
Always wear safety gear when operating or servicing equipment.
Helmet, Safety belt : Use during the work at height.
Safety gloves : Use when applying lubricant and when handling organic solvents.
Safety glasses : Use when applying lubricant and when handling organic solvents.