00198829-01_SM_X-Series-S_Hxxxx_EN.pdf - 第100页
5 Pneumatic System 5.12 Vacuum Pump 100 Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021 5.12.2 Replacing the filter insert Read the job cards for your machine. Parts, equipment and tools Fig.123: Filter insert ● …
5 Pneumatic System
5.12 Vacuum Pump
Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021 99
5.12 Vacuum Pump
DANGER
Observe User Manual
► Please observe the safety instructions in the user manual for all work!
NOTICE
Different vacuum pump versions
The following tasks are described using the new version "Vacuum pump Becker VX 4.25
IE3 with cable" [03212135Sxx]. The procedure is the same for the old version
[03069679‑xx]. Any relevant differences will be mentioned explicitly.
5.12.1 Replacing the pump and spare parts
Parts
Fig.122: Becker VX 4.25 IE3 vacuum pump with cable [03212135-xx]
●
Becker VX 4.25 IE3 vacuum pump with cable [03212135Sxx] (replaces [03069679-xx])
●
Filter insert [03077677‑xx]
See 5.12.2
"Replacing the filter insert" [}100]
●
Slide set [03077679‑xx]
See 5.12.3
"Replacing the slide set" [}101]
For other spare parts, see the catalogue of parts.
Removal/installation
Refer to the assembly instructions for your machine for this:
●
Assembly instructions "Option Vacuum Pump SIPLACE X-Series S from Hxxxx " [DEEN:
00198599‑xx]
5 Pneumatic System
5.12 Vacuum Pump
100 Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021
5.12.2 Replacing the filter insert
Read the job cards for your machine.
Parts, equipment and tools
Fig.123: Filter insert
●
Filter insert [03077677‑xx]
Removal/installation
► Switch off the machine, disconnect it from the power supply and secure it to prevent
unauthorized reactivation.
1.2 "Preparatory work..." [}16]
► Switch off the compressed air supply and then disconnect the machine from the compressed
air supply.
5.2 "Disabling the compressed air supply" [}86]
Fig.124: Retaining clips (example of SIPLACE SX2 shown)
► Open the edgewise retaining clamps of
the filter casing and remove the cap.
5 Pneumatic System
5.12 Vacuum Pump
Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021 101
Fig.125: Vacuum filter (example of SIPLACE SX2 shown)
► Remove the filter insert(1).
► Check the filter insert and replace if ne-
cessary.
5.12.3 Replacing the slide set
Parts
Fig.126: Slide set
●
Slide set [03077679‑xx]
Removal/installation
► Switch off the machine, disconnect it from the power supply and secure it to prevent
unauthorized reactivation.
1.2 "Preparatory work..." [}16]
► Switch off the compressed air supply and then disconnect the machine from the compressed
air supply.
5.2 "Disabling the compressed air supply" [}86]
Depending on the installation situation, removing the vacuum pump for maintenance tasks can be
useful (see assembly instructions).