00198829-01_SM_X-Series-S_Hxxxx_EN.pdf - 第246页

7 Conveyor 7.10 Conveyor sides 246 Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021 7.10 Conveyor sides 7.10.1 Setting the Fixed Conveyor Side 7.10.1.1 Setting the Fixed Conveyor Side on Single Conveyors CAUTION Mo…

100%1 / 382
7 Conveyor
7.9 Boards
Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021 245
Fig.323: TSP420 machine plate SIPLACE X4 S
7 Conveyor
7.10 Conveyor sides
246 Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021
7.10 Conveyor sides
7.10.1 Setting the Fixed Conveyor Side
7.10.1.1 Setting the Fixed Conveyor Side on Single Conveyors
CAUTION
Moving the conveyor sides
► The conveyor sides are highly sensitive. Move them very carefully and evenly. Take
special care not to distort the conveyor sides.
Overview
Fig.324: Overview of side wall positions
1. Position 231.0 mm
Max. PCB width: 460mm
2. Position 256.0 mm
Max. PCB width: 560mm
3. Position 281.0 mm
Max. PCB width: 560mm
4. Position 344.0 mm
Max. PCB width: 685mm
The conveyor side is fixed with two fastening
screws each point from (1)
to (4).
Setting
► Use the software to move the conveyor sides into a position which allows you best access.
► Switch off the machine, disconnect it from the power supply and secure it to prevent
unauthorized reactivation.
1.2 "Preparatory work..." [}16]
► Always perform the following three steps immediately at the three holders.
Fig.325: Setting the conveyor side position
► Remove the screws (1) fastening the conveyor side (two screws per holder).
NOTICE
You can also loosen two screws on the connection between the side wall and the flange, to
prevent distortion during movement. The side wall is otherwise very difficult to move.
7 Conveyor
7.10 Conveyor sides
Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021 247
► Move the conveyor side into the required position.
► Insert the screws loosely. Press the side so that it engages with the screw holes either in a
forwards or backwards inclination (against all three holders in the same direction). Tighten the
fastening screws in the new position.
Fig.326: Setting the conveyor side
► In the software set the fixed conveyor
side and the position.
 NOTICE!
This menu is accessible from operator
level Service (customer)!
.
7.10.1.2 Setting the Fixed Conveyor Side on Dual Conveyors
The fixed conveyor edge is always set with the software for dual conveyors.
Setting
Fig.327: Setting the conveyor side position
► In the software set the fixed conveyor
side and the position.
Conveyor Sides - Settings
 NOTICE!
This menu is accessible from operator
level Service (customer)!
.