00198829-01_SM_X-Series-S_Hxxxx_EN.pdf - 第304页
9 Component feeding 9.1 Cutter 304 Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021 9.1.12 Replacing Wiper Clip Parts Fig.421: Wiper left and right 03000506‑xx Wiper clip left (SIPLACE HF) 03000505‑xx Wiper clip, …
9 Component feeding
9.1 Cutter
Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021 303
Overview
Fig.418: Wiper on cutter
1. Wiper
Removal
► Switch off the machine, disconnect it from the power supply and secure it to prevent
unauthorized reactivation.
1.2 "Preparatory work..." [}16]
► Remove the cutter from the machine.
9.1.4 "Replacing the Cutter on the COT Insert [03066690-xx]" [}285]
Fig.419: Cover plate
► Remove the screws(2) fastening the
top cover plate(1)
and then remove the
top cover plate.
Fig.420: Removing the wiper
► Remove the two screws(1) fixing the
wiper(2)
.
► Remove the wiper(2).
The notch(3)
in the wiper will move
over the articulated joint(4)
on the
short-stroke cylinder.
Installation
Follow the removal instructions in reverse order for installation.
9 Component feeding
9.1 Cutter
304 Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021
9.1.12 Replacing Wiper Clip
Parts
Fig.421: Wiper left and right
03000506‑xx Wiper clip left (SIPLACE HF)
03000505‑xx Wiper clip, right (cutter HF)
Equipment and tools
00353832-xx Allen key set
Wire cutters
Cable tie
Overview
Fig.422: Wiper clips on cutter
1. Wiper clips
9 Component feeding
9.1 Cutter
Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021 305
Removal
► Switch off the machine, disconnect it from the power supply and secure it to prevent
unauthorized reactivation.
1.2 "Preparatory work..." [}16]
► Remove the cutter from the machine.
9.1.4 "Replacing the Cutter on the COT Insert [03066690-xx]" [}285]
► Remove the wiper.
9.1.11
"Replacing the wiper" [}302]
Fig.423: Removing the wiper clips
► Remove the two screws(1) (left and
right) and remove the wiper clips(2)
.
Installation
Fig.424: Installing the wiper clips
► Install the new wiper clips(2) on both
sides and loosely put the screws(1)
back in.
► Align the wiper clips to the edges of the
cutter frame(3)
and to the cutter top
blade(4)
.
► Tighten the screws(1) fixing the wiper
clips.
Follow the removal instructions in reverse order for further installation.