00198829-01_SM_X-Series-S_Hxxxx_EN.pdf - 第40页
2 Basic Machine 2.8 Nozzle Changers and Reject Boxes 40 Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021 2.8.3 Replacing the Nozzle Changer NOTICE Row two, MTC2, WPC For more information about the row 2 nozzle chan…
2 Basic Machine
2.8 Nozzle Changers and Reject Boxes
Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021 39
Fig.33: Sensors for reject bin SIPLACE X-Series S with JTF
Fig.34: Sensors for reject bin SIPLACE X-Series S with JTF
2 Basic Machine
2.8 Nozzle Changers and Reject Boxes
40 Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021
2.8.3 Replacing the Nozzle Changer
NOTICE
Row two, MTC2, WPC
For more information about the row 2 nozzle changers and in combination with MTC2/
WPC, refer to the assembly instructions "NC row 2 - NC before MTC 2/
WPC" [DEEN:00197369‑xx].
Parts, equipment and tools
Select the relevant nozzle changers:
●
NC basic structure CPx/all assembly long [03147324–xx] (replaces [03103514‑xx]
[03070123‑xx])
●
NC CPx/all short [03147925‑xx] (replaces [03103649-xx] [03062463-xx])
●
Magazine holder assembly / NC P+P B series [03062453‑xx]
●
If required, NC shim plates [03021079-xx]
●
Depth measuring gauge (300mm) [03079617-xx]
●
Plastic plate
Overview
Fig.35: Nozzle changer with four nozzle magazines
1. Four nozzle magazines (4xxx/6xxx)
2. Four fixing screws
3. Four levers for removal of nozzle
magazines
4. Cover on the underside
The electronic and pneumatic compon-
ents are under the cover.
Fig.36: Overview of nozzle changers
1. Cover
2. Electrical connection
3. Compressed air connection
4. Valve
2 Basic Machine
2.8 Nozzle Changers and Reject Boxes
Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021 41
Removal
NOTICE
Short and long nozzle changer
The procedure for removal and installation is the same for the short and long nozzle
changer.
► Switch off the machine, disconnect it from the power supply and secure it to prevent
unauthorized reactivation.
1.2 "Preparatory work..." [}16]
► Switch off the compressed air supply
5.2 "Disabling the compressed air supply" [}86]
► Remove all magazines.
► Remove the four fastening screws.
► Unplug the nozzles changer from all electrical and pneumatic connections. You might like to
mark their positions to make clear assignment easier later on.
► Take care not to lose the support plates. Remember their exact positions, as they will need to
be returned to these original positions, during assembly.
► Carefully lift the nozzle changer out of the machine.
Installation
Follow the removal instructions in reverse order for installation. Also observe the following instruc-
tions:
► If present: check the jumper on the nozzle changer.
2.8.6 "Jumpers on the Nozzle Changer" [}44]
► Re-insert the support plates.
► Check the mechanical installation height of the nozzle changer.
2.8.5 "Setting the Nozzle Changer Height" [}43]