80S-2080F480F4-680F5 User’s Manual.pdf - 第678页

SIPLACE 80S-20/F4/F4-6/F5 User’s Manual 11 Station Extensions/Options Edition 03/98 from Software Version SR.404.xx 11.11 Feeder Position Recognition 11 - 81 11.11 Feeder Position Recognition 11.11.1 General The feeder s…

100%1 / 744
11 Station Extensions/Options SIPLACE 80S-20/F4/F4-6/F5 User’s Manual
11.10 Twin Conveyor Edition 03/98 from Software Version SR.404.xx
11 - 80
SIPLACE 80S-20/F4/F4-6/F5 User’s Manual 11 Station Extensions/Options
Edition 03/98 from Software Version SR.404.xx 11.11 Feeder Position Recognition
11 - 81
11.11 Feeder Position Recognition
11.11.1 General
The feeders can be measured if they are equipped with fiducials.
This function also supports the wafflepack magazine holder (manual tray holder) if it is equipped with fiducials.
If the "Feeder position recognition" function is preset by the line computer, then this function will appear in the
machine options.
In the machine options you can also activate or deactivate feeder position recognition at the station con-
cerned.
Fig. 11.11.1 Feeder position recognition
PLEASE NOTE:
The "Feeder position recognition" function is always switched off when the station is switched on.
F
11 Station Extensions/Options SIPLACE 80S-20/F4/F4-6/F5 User’s Manual
11.11 Feeder Position Recognition Edition 03/98 from Software Version SR.404.xx
11 - 82
If the user data contains an entry for a track, the position of the centering fiducial on the feeder concerned is
approached with the PCB camera. Any centering fiducial offset identified during the measuring process is
then allocated to this track and is added to the pick-up position during the pick-up operation.
11.11.1.1 Restrictions
- The feeder position recognition function cannot be used for magazine holders that are set up in the waf-
flepack changer.
- Up to three fiducial positions can be defined for each feeder.
- Feeder fiducials on the right side of the table (viewed in the transport direction) cannot be measured on the
80F.
PLEASE NOTE:
This restriction does not apply to machines with "Under-gantry camera".
- If there is a feeder at location 118 and the fiducial position of the outer pick-up compartment is closer to the
traveling range limit of the x axis than the pick-up position, then the 8 mmS tape and bulk case feeder can-
not be measured.