2OM-1733-005w_F8.pdf - 第144页

2OM-1733 2-3-10 (B01_05) Comp library placement offset In this box, whether or not the component library placement offset function is used, is setup. When "Enable" is set, the system is operated based on the va…

100%1 / 358
2OM-1733
2-3-9
Front Right
: The placement coordinate reference is based on the front
right side and specied as follows.
X +
Y +
Placement Coordinate Reference (No)
PCB
F2B3-11
Rear Right
: The placement coordinate reference is based on the rear
right side and specied as follows.
X +
Y +
Placement Coordinate Reference (No)
PCB
F2B3-12
Notice
Be sure to set the same reference as the input and output machines.
Ifareferencedifferentfromtheinputandoutputmachinesisspecied,
PCBs cannot be produced correctly.
Note
When a different reference is specied in the pattern program and the program
is to be used for this machine, be sure to change the reference of this machine to
the different one.
1212-002
3.2 PCB
2OM-1733
2-3-10
(B01_05)
Comp library placement offset
In this box, whether or not the component library placement offset function
is used, is setup.
When "Enable" is set, the system is operated based on the value set in the
NT-100 system software.
(B01_06)
PCB Warpage [mm]
Specify the maximum value of the PCB upward warpage.
Notice
Whenever the data is changed, be sure to optimize the data.
•
Data Input Range
0.000 to 3.000
(B01_07)
Lot Name
The lot name of the pattern program is set in this text box.
Max. 39 characters are used for the setting.
The available characters are half-width alphabetical and numerical characters
and symbols.
Note
Even when this comment is not set, it does not inuence on the machine
performance.
(B01_08)
Comment 1 and Comment 2
Comments on the pattern program can be specied in these text boxes.
Up to 32 characters (alphanumerics and marks) can be used.
Note
The performance of the machine is not affected by these comments. In
other words, it has nothing to do with or without these comments.
1212-002
3.2 PCB
2OM-1733
2-3-11
3.3 Operation
(C01) Function
Fig. 2B3-13
Note
The number of pages varies depending on the number of zones to be used.
Graphic
Development
1212-002
3.3 Operation