2OM-1733-005w_F8.pdf - 第83页
2OM-1733 1-4-7 4.2 "Opr .Mode" T ab Sheet When the [Opr.Mode] tab is pressed, the "Opr.Mode" tab sheet (1st page) appears as an initial one. [1] [2] Fig. 2A4-7 " Opr.Mode " Tab sheet (1st pa…
2OM-1733
1-4-6
•
"Run Mode" Window in "Placement Recovery Available" Mode
When a pre-pick nozzle conrmation error occurs, the placement recovery
function becomes available.
In this case, the [Placement Recovery] button appears in the window.
Fig. 2A4-6
[1] [Plc Pos Move] Button
When pressed, this button opens the "Placement Step Recovery" window.
Reference
A pre-pick nozzle conrmation error will not occur when the pre-pick
nozzle conrmation function is not used.
Refer to "4.2 Opr. Mode Tab Sheet" in "Chapter 1" for how to use the pre-
pick nozzle conrmation function.
Note
When the machine is reset to its normal condition from the "ERROR"
window after a pre-pick nozzle conrmation error has occurred, the
"Placement Step Recovery" window appears automatically.
This window becomes available when the placement step recovery is
interrupted for an unaccountable reason and a recovery operation must be
performed again.
[2] [Cancel Place Rcvry] Button
When pressed, the placement recovery is cancelled.
1212-002
4.1 "Run Mode" Tab Sheet
2OM-1733
1-4-7
4.2 "Opr.Mode" Tab Sheet
When the [Opr.Mode] tab is pressed, the "Opr.Mode" tab sheet (1st page) appears
as an initial one.
[1]
[2]
Fig. 2A4-7
"
Opr.Mode
"
Tab sheet (1st page)
[1]
Fig. 2A4-8
"
Opr.Mode
"
Tab sheet (2nd page)
Graphic
Development
1212-002
4.2 "Opr.Mode" Tab Sheet
2OM-1733
1-4-8
[1] "Opr.Mode" Select
The setting is performed in this area for the selected button.
When the setting has been changed, press the [Apply] button to apply the
setting.
[2] Common Button
[Init Value] Button
When pressed, the set condition parameters are returned to the initial values.
[Apply] Button
When pressed, the changed setting is applied.
[Cancel] Button
When pressed the changed setting is returned to the one prior to the change.
1212-002
4.2 "Opr.Mode" Tab Sheet