2OM-1733-005w_F8.pdf - 第163页

2OM-1733 2-3-29 PCB Bottom [mm] When PCBs with some components already mounted on the lower surfaces (back) by the input machine are transferred to this machine, be sure to enter the thickness of the highest component in…

100%1 / 358
2OM-1733
2-3-28
(D01_03)
Pre-PL cmpnt thkns
PCB Top [mm]
When some components are placed previously on a PCB by the input
machine, etc., and transferred to the main machine, be sure to enter the
thickness of the tallest component of all in the text box.
Tallest Previously Placed Component
Set this thickness in the text box.
PCB
Fig. 2B3-27
•
Data Input Range
0 to 2.000 (0 to 12.700)
Notice
(a) When components are placed previously and the main machine
is operated with "0.00" (no previously placed components) in
this text box, some of the previously placed components may
interfere with components to be placed newly.
(b) It is advisable that placement data should be created such that
shorter components are placed before the tallest one.
(c) Whenthespeciedthicknessofapreviouslyplacedcomponent
differs from the actual one, the light emitter of the linear
measure sensor may interfere with the previously placed
component.
(d) Theguresforthesettingrangeinbracketsshowthevalues
for the high-speed head SIGMA-F8 (HL).
2.0 mm
4.0 mm
2.0 mm
3.0 mm
2.0 mm
NL Origin Position NL Origin Position
Light
Emitter
Light
Emitter
Previously
Placed
Component
PCB
Placement Level
No Previously Placed Component Previously Placed Component
Fig. 2B3-28
1403-004
3.4 Control
2OM-1733
2-3-29
PCB Bottom [mm]
When PCBs with some components already mounted on the lower surfaces
(back) by the input machine are transferred to this machine, be sure to enter
the thickness of the highest component in the text box.
Tallest Previously Placed Component
PCB
Set this thickness in the text box.
Fig. 2B3-29
•
Data Input Range
0 to 13.000 (0 to 30.000)
Notice
(a) The set parameter is used to determine the position (elevation)
oftherstbackuptablewhenthePCBistransferredtothe
PCB positioning section.
(b) When components are placed previously and the main machine
is operated with "0.00" (no previously placed components) in
this text box, the support pins may interfere with some of the
previously placed components on the back of PCB while the
PCB is being transferred to the PCB positioning section.
(c) Theguresforthesettingrangeinbracketsshowthevalues
for the Y510mm Single Transfer Unit (Option).
1403-004
3.4 Control
2OM-1733
2-3-30
(D02) PCB locate
When the [PCB locate] tab is pressed in the "Control" window, the following
tab sheet appears.
Fig. 2B3-30
F2B3-31 Using vacuum support
Note
The vacuum support is an optional function.
Graphic
Development
1403-004
3.4 Control