2OM-1733-005w_F8.pdf - 第159页

2OM-1733 2-3-25 (C05_05) M-X, M-Y Using these selection boxes, the support pin placement coordinates (M-X, M-Y) are setup. Coord X, Coord Y The set support pin coordinates are displayed in these data boxes. • Data Input …

2OM-1733

2-3-24

(C05_02)

Support Pin

Using this selection button, it is set whether or not the support pins are setup

automatically in the pattern program change operation.

(C05_03)

Num of Pin using

The number of pins to be used in the automatic operation is set in this

selection box.

•

Data Input Range

1 to 40 pins

(C05_04)

Table

Using this selection box, it is set that the backup base where the support pins

are placed, is in the output or input.

1212-002

3.3 Operation

2OM-1733

2-3-25

(C05_05)

M-X, M-Y

Using these selection boxes, the support pin placement coordinates (M-X,

M-Y) are setup.

Coord X, Coord Y

The set support pin coordinates are displayed in these data boxes.

•

Data Input Range

Input

M-X

: 1 to 26

M-Y

: 1 to 24 (1 to 50)

Output

M-X

: 1 to 26

M-Y

: 1 to 24 (1 to 50)

Note

(a) When the [Pin] button is pressed, the "Support Pin" dialogue box is

opened and the support pin positions can be checked.

Fig. 2B3-24

(b) When the [Clear] button is pressed, the support pins with the selected

Nos. are cleared.

Y510mm Single Transfer Unit (Option).

1403-004

3.3 Operation

2OM-1733

2-3-26

3.4 Control

(D01)

Control

When the [Control] tab is pressed in the "Control" window, the following tab

sheet appears.

Fig. 2B3-25

(D01_01)

Placement mode

"Product" or "Pass" is selected for the placement mode in this pane.

Normally, "Product" is selected.

Product

: When selected, the placement operation is performed.

Pass

: When selected, the PCB is passed without placement.

Note

When the pattern program set to "Pass", is setup on the Pattern Program

Data, the vacuum pump is automatically turned OFF.

Graphic

Development

1212-002

3.4 Control