OM-1068-001.pdf - 第106页

5. Preparation and Confirmation before Operation Tg0252-PM-SO (4) Put the knob of the magazine stopper between fingers as shown in Fig. 1.30 and turn it clockwise by approx. 90 ° ‹while pulling it forward. (See Arrows *1…

5. Preparation and Confirmation before Operation

Tg0252-PM-SO

5.2.3 Attachment and Detachment of Magazine

5.2.3.1 Attachment of Magazine

Described below is how to attach the magazine to the internal sections of the

elevator for the first time after a multi-layer tray feeder is installed.

(1) Perform the zeroing operation.

Refer to “2. Zeroing Operation of Section 4 in Chapter 1” and “11.1.2

Zeroing Operation Maneuvered on Main Machine Side of Section 2 in

Chapter 1” for details.

(2) Press the [U READY] or the [L READY] button on the magazine loaded

side.

The LED of the pressed button extinguishes.

Ref.: While the LED of the [U READY] or the [L READY] button is

“ON”, the door (the upper or the lower door) cannot be opened.

(3) Hold the grip of the door whose button is pressed in Step (2) and pull it

forward to open the door.

Fig. 1.28-1 Rough View (FP-5021L)

Fig. 1.28-2 Rough View (FP-5021R)

Magazine Base

Upper

Door

Lower

Door

Grip

[L READY] Button

[U READY] Button

Magazine Base

9911-001 Chapter 1 2-22

5. Preparation and Confirmation before Operation

Tg0252-PM-SO

(4) Put the knob of the magazine stopper between fingers as

shown in Fig. 1.30 and turn it clockwise by approx. 90°

‹while pulling it forward.

(See Arrows *1 and *2 in Fig. 1.29.)

Ref.: Pulling Force of Magazine Stopper

39.2 N to 49.0 N (4 to 5 kgf)

Fig. 1.29

Fig. 1.31 Grips of Magazine “MG-5050L” (Same to “MG-5050R”)

(5) Hold the handle of the magazine base and pull it forward until it stops.

Locking Pin

Block

Fig. 1.30 Magazine Base

Knob Handle

Approx. 90°

Magazine Stopper

0112-003 Chapter 1 2-23

Grip of Magazine

5. Preparation and Confirmation before Operation

Tg0252-PM-SO

(6) Hold the magazine handle (Refer to Fig. 1.31) and set the magazine care-

fully on the magazine mounting section: then press the magazine against

the rear stopper.

Confirm that the magazine is set in place along the side and rear stoppers

and is not tilted.

Fig. 1.33 The status before folding the grip of the magazine.

“MG-5050L” (Same to “MG-5050R”)

Fig. 1.32 Magazine Base (Slid Out)

Note: There are two types of magazines - “MG-5050L” for “FP-

5021L” and “MG-5050R” for “FP-5021R”. Do not make a mis-

take of wrong selection. Otherwise, an error will occur.

(7) Fold down (close) the grips of the magazine.

Note: When the magazine is pushed inward with the grips kept open,

the grips will be caught by the multi-layer tray feeder, blocking

the way to the rear end.

0112-003 Chapter 1 2-24

Side Stopper Side Stopper

Rear Stopper