YCP10 Users_E.pdf - 第87页
3-11 3 Printing guide 5. Press the [Close] button to close the T each screen. T he screen then returns to the previous screen, and the value obtained from the teaching is set in "v . Board Edge Offset Lower Left&quo…
3-10
3
Printing guide
3. The message screen appears. Follow the instructions to set the board at the carry-in port, and then press the [OK]
button.
After the board has been transferred to the board clamp position, the board vision camera moves to the position where
the board detection sensor starts responding and the Teach screen will appear.
Board edge offset
Message screen
64307-N1-00
4. Operate the arrow buttons to display the board edge at the center of the screen, and then press the [Teach] button.
Board edge offset
Teach screen
Operate these buttons to display the board edge at the center.
64308-N1-00
TIP
When pressing the [Convey Board] button, the board is moved to the entrance or exit, and then it is transferred to the
detection sensor again.
When you want to perform the teaching again or make the check again with the values obtained from the teaching,
press this button to perform the operation again.
3-11
3
Printing guide
5. Press the [Close] button to close the Teach screen. The screen then returns to the previous screen, and the value
obtained from the teaching is set in "v. Board Edge Offset Lower Left" or "w. Board Edge Offset Lower Right".
Teaching completion
Example of "v Board Edge Offset Lower Left"
The value is entered.
64309-N1-10
3.2.3 Conveyor motor (board transfer) speed
n
Function
This function changes the conveyor motor (board transfer) speed.
n
Setting procedure
Set "o. Conveyor Motor Speed" on the [Print]-[Board] tab screen.
The data set in the machine setting is determined to the standard. To increase the speed, set a speed in a range of +10%
to +50% from this standard in 10% steps. Conversely, to decrease the speed, set a speed in a range of -10% to -90% from
the standard in 10% steps.
n
NOTE
· To increase the tact, increase the speed.
· To make the stop position stable, decrease the speed.
3-12
3
Printing guide
3.2.4 X-axis movement during board transfer
n
Function
This function optimizes the X-axis coordinate of the print table when delivering the board between the upstream and
downstream machines so as to minimize the time loss associated with the movement.
n
Setting procedure
Set "z. X-Axis Move For Board Transfer" on the [Print]-[Board] tab screen.
Use: The X-axis (print table) is moved and transfers the board when delivering the board between the upstream and
downstream machines.
Not Use: The X-axis (print table) does not move to the soft limit when delivering the board between the upstream and
downstream machines.
c
CAUTION
This function is enabled only when the board size X is 100.0 mm or more.
When the board size X is less than 100.0 mm, this function performs the operation with "Not Use" setting regardless of
the setting.
X-axis movement during board transfer
■ Operation when selecting "Use". ■ Operation when selecting "Not Use".
Transfer direction (right → left) Transfer direction (right → left)
X-axis movement
Board
Upstream machineDownstream machine Upstream machineDownstream machine
Board
X-axis movement
X-axis movement
X-axis movement
63309-N1-00