3OM-1003-005.pdf - 第302页

*2 X [mm], Y [mm] This is the offset data for the head rotational center based on the component recognition camera (Camera #1: high magnification) center of each head. Each head rotational center position is managed at S…

(3) "Head Center Offset" Tab

• Sheet Layout

When the "Head Center Offset" tab is pressed in the "Head" tab sheet,

the following tab sheet appears.

Fig. 3E23 "Head Center Offset" Tab Sheet

• Sheet Composition

*1 Head

The head Nos. are displayed.

*1 *2

3.2 "Device Offset" Tab

0305-001 5-22 AIL01EDTP

*2 X [mm], Y [mm]

This is the offset data for the head rotational center based on the

component recognition camera (Camera #1: high magnification)

center of each head.

Each head rotational center position is managed at Station #3 (Com-

ponent Recognition) and plus and/or minus values are automati-

cally entered on the basis of the design values (X = 7.500 mm, Y =

0.000 mm).

(a) These offset values are automatically calculated through

teaching operation.

(b) These offset values are used for calculation of place-

ment position correction at component placement.

Fig. 3E24

0305-001 5-23

AIL01EDTP

3.2 "Device Offset" Tab

Note

3.2.3 "CPK Offset" Tab

The "CPK Offset" tab sheet is composed of "Master Offset" tab.

• Sheet Layout

When the "CPK Offset" tab is pressed in the "Device Offset" tab sheet,

the following tab sheet appears.

Fig. 3E25

• Sheet Composition

*1 "Master Offset" Tab

When selected, the "Master Offset" tab sheet appears.

0305-001 5-24

AIL01EDTP

3.2 "Device Offset" Tab