3OM-1003-005.pdf - 第303页

3.2.3 "CPK Offset" T ab The "CPK Offset" tab sheet is composed of "Master Offset" tab. • Sheet Layout When the "CPK Offset" tab is pressed in the "Device Offset" tab shee…

*2 X [mm], Y [mm]

This is the offset data for the head rotational center based on the

component recognition camera (Camera #1: high magnification)

center of each head.

Each head rotational center position is managed at Station #3 (Com-

ponent Recognition) and plus and/or minus values are automati-

cally entered on the basis of the design values (X = 7.500 mm, Y =

0.000 mm).

(a) These offset values are automatically calculated through

teaching operation.

(b) These offset values are used for calculation of place-

ment position correction at component placement.

Fig. 3E24

0305-001 5-23

AIL01EDTP

3.2 "Device Offset" Tab

Note

3.2.3 "CPK Offset" Tab

The "CPK Offset" tab sheet is composed of "Master Offset" tab.

• Sheet Layout

When the "CPK Offset" tab is pressed in the "Device Offset" tab sheet,

the following tab sheet appears.

Fig. 3E25

• Sheet Composition

*1 "Master Offset" Tab

When selected, the "Master Offset" tab sheet appears.

0305-001 5-24

AIL01EDTP

3.2 "Device Offset" Tab

(1) "Master Offset" Tab

• Sheet Layout

When the "Master Offset" tab is pressed in the "CPK Offset" tab sheet,

the following tab sheet appears.

Fig. 3E26 "Master Offset" Tab Sheet

• Sheet Composition

*1 Offset [deg]

Displayed are the angles (0, 90, 180, and 270) specified in the place-

ment data.

*2 Theta [deg]

This is the offset data for angle difference between the X/Y table and

camera coordinate systems.

0305-001 5-25

AIL01EDTP

3.2 "Device Offset" Tab

*1 *2 *3 *4