MV-9_Chapter 5. Teaching.pdf - 第234页
MV -9 Use r Manual 5- 234 This option will be activated onl y w hen „Use opti on dev i ce/NG m arker ‟ opt i on in „m a chine setting ‟ in „login o ption‟ is checked . set p arameter of NG m arker related t o NG marking …
错误!使用“开始”选项卡将 제목 2 应用于要在此处显示的文字。错误!使用“开始”选项卡将 제목 2 应用
于要在此处显示的文字。 .
5-233
This is used to change format of serial No used during inspection and to re-set serial No.
To change serial No format, click < > button.
Change format character in serial No format as shown in the figure below and click <OK>
button.
[Figure 5-305 serial No format setting screen]
Default value
This is used to ignore serial No until now and reset serial No to „0‟. The screen below will
be displayed.
[Figure 5-306 DB data deletion selection]
Click <Yes (Y)> button to delete inspection DB data and defect image inspected so far
and reset serial No to „0‟. Click <No (N)> button not to delete inspection DB data but to
reset serial No to „0‟.
Defect image folder
Click <Open> button to open search screen as defect image save folder position of
current inspection model and to display or delete saved defect image. Click <delete>
button to delete all saved defect images.
SPC & repair
To display statistics data or defect information in SPC and repair program, SPC and repair
related option and „Save inspection result‟ option must be setting at „Config.‟ Click
<delete> button to remove DB data and defect image of all SPC and repair inspection
saved until now.
PCB model information ‘NG marker’ tap
Edit Type of Serial Number to Change.
MV-9 User Manual
5-234
This option will be activated only when „Use option device/NG marker‟ option in „machine
setting‟ in „login option‟ is checked. set parameter of NG marker related to NG marking for
defect component after model inspection.
[Figure 5-307 DB PCB model information - NG marker tap]
„NG marking‟ option
This option will be checked for NG marking for defect component after inspection.
Marking type setting
To designate marking at component center, select „component‟, and designate X/Y-axis
edge of board for defect component, select „X‟/„Y‟.
Marking position setting
i. Firstly, move robot to board edge to set X/Y position.
ii. Click <position setting> button that is activate when X/Y is selected.
iii. For marking of defect component at the center of the current position, move toward
X/Y-axis direction for marking.
Setting of NG Marking Use
Setting for Marking Type
Setting for Marking Location
错误!使用“开始”选项卡将 제목 2 应用于要在此处显示的文字。错误!使用“开始”选项卡将 제목 2 应用
于要在此处显示的文字。 .
5-235
[Figure 5-308 X/Y-axis marking position setting]
PCB model information ‘bar code reader’ tap
„Option device/bar code reader‟ must be set in „machine setting‟ in „login option‟. When
inspection is started, serial No of inspection model can be read at bar code position by reading
bar code.
[Figure 5-309 PCB model information – bar code reader tap]
„Bar code reader‟ option
Whether to Use Bar Code
Setting for the coordinate of barcode
Light Setting
Setting for the type of the barcode
Barcode Connection Test
PCB
Frame position of current robot
X/Y axis line for marking